My electric ultimate care II Whirlpool dryer will blow air but will not heat. The model number is LEQ8000JQ3. I've seen a posting with the same problem for a gas model that mentions it could be a blown thermal fuse. Is this also possible for the electric version?
Thank you for any insight!
Yes its located on the houseing where the heating element is and is a small round disc with two wires get a putty knife and push in between the top panel and body of the drier about 2-3inches of the edge lifting the top as you do remove the front panel by removing the two 5/16 in screws and pull the panel the locate the heating coil and check the thermal limiter
671 views
Usually answered in minutes!
Model # LEQ9858PWO
I have no heat when the dryer runs. So far I have replaced the the two main fuses and the thermal fuse. What's my next step?
×