The MSM 422 Access Point is not booting up, just restarting all the time. This is the error message: CPU: Motorola PowerPC 8241/8245 Version: 5.4 BSP version: 1.3 Bootcode version: 3.0.6 Creation date: Apr 13 2005, 10:11:43 BOOT LINE being initialized, please wait! FLASHDRV_DataWrite:ERROR: Program-buffer-to-Flash command failed Press specific key to stop auto-boot... 1 auto-booting... bootLoad: Entering... boot device : fs: unit number : 0 processor number : 0 file name : /fl/dflt-img.bin flags (f) : 0x0 Auto Flash-Detect : 4M Product Name Detect: Flash Mode (0) bootLoad: Found file /fl/dflt-img.bin! bootLoad: Size of file is 1109249 Successfully inflated file Starting at 0x20000...

The main board in defective.
Not able to boot

Your best bet , have it checked for DTC'S - diagnostic trouble codes first ! Electronic control modules involved ! Can't check with a OBD 2 code reader , need advanced scan tool . No codes , check B+ voltage and ground to the module .
Power Seat Inoperative (With Memory A45)
Memory Seat Feature Inoperative
Circuit/System Description
Battery voltage is supplied at all times to the memory seat module (MSM) from the MDL-MEM 10A fuse located in the rear fuse block. This voltage is used by the MSM for logic power and to supply battery reference voltage to the seat and lumbar adjuster switches. Battery positive voltage is also supplied at all times to the MSM from the PWR SEAT 25A circuit breaker. This voltage is connected to a power rail internal to the MSM and is used to drive the power seat motors, lumbar motors, and seat heater elements on vehicles equipped with heated seats. Each seat and lumbar adjuster motor is controlled by the MSM through 2 motor control circuits. The MSM connects all motor control circuits on the power rail to a common reference point whenever they are not in operation. This reference point is biased to approximately 2.5 volts. The MSM checks to see if the reference voltage is shorted to ground or battery before enabling any of the seat or lumbar motors.

Circuit/System Description
Reference voltage is supplied to the memory switch from the driver door module (DDM). When a memory switch is pressed, reference voltage is applied through the switch contacts, a series of resistors and thorough the memory switch signal circuit to the DDM. The door module then sends a serial data message to the memory seat module (MSM) indicating the memory recall request. The MSM then commands the appropriate seat motors to move to the pre-recorded seat positions stored in memory in response to the switch input.

Your Mac is an Intel-based computer (see About this Mac in Apple menu), but the software to setup the printer was produced a long time ago for Macs that had PowerPC processors. Apple hasn't support PowerPC Macs since OS X 10.4 (Tiger). If you really need supporting utilities for the printer, search for "Lexmark X5100 for Intel Mac" on the web.

DriverPack Solution driver update software Download Windows 7 XP 10 8 and...

MSM6280 Downloader ver 5.43

This is because of the improper configuration of the access point. so you make a request the service provider to send the settings and store the same in the phone then restart it to get the things done

u cant do it by ur own, u need to go to motorola service center to get it a software update

HP Deskjet d2360

RE-Install Windows

I bought a Compaq Computer, 2.0Ghz, 256MB, 20GB for my College project. When i put the power on, it restarts almost immediately (so many times repeatedly). Then after such reboots, it successfully brings a message "1801 - Microcode Patch Error" and a F1-Boot directive.