Have a jazzy 1113. The speed profile lights flash then the chair shuts off. The batteries show full.

Gel Cell is always better

check wiring and pcb in your chair...it may be loose connection in between the path

The voltmeter should read 29 volts when on. You should never replace one battery and leave an old battery in the chair. Replace them both at the same time.

3 flashes indicate that there is a short circuit to the left motor and battery connection. Check wiring and connections

If all lights are flashing excessive voltage has been applied to the controller system. 6 flashing lights on the 1133 indicates that the chair is being inhibited by the battery charger. Try unplugging the battery charger. Check you battery connections.

It appears that the controls are in Lock Mode. Unlocking Instructions depend on your type of controller. Go to PrideMobility.com to download the proper manuals for chair and controller.

thats a fault code call 1-800-800-8586 for tech assistance

my chair jazzy 1113 ats won't move.all the lights are flashing and the batteries are fully charged why are they flasng

Jazzy is in lock mode try the following to unlock:

Lock Mode

To unlock the VSI:

1. Press the on/off key and power on the VSI. The maximum speed/profile indicator should ripple side to side.

2. Push the joystick to the full forward position until the VSI beeps.

3. Pull the joystick to the full rearward position until the VSI beeps.

4. Release the joystick. There should be a long beep.

5. The VSI is now unlocked

Hope this helps

If your batteries are truly charge they should read around 24.5 VDC. And if the freewheel lever is engaged and you still have no movement your probably need to get into a service tech. Also check the circuit breaker on the chair.