Powers on but hangs on the hello screen. It appears to lock up. I have 113 of these items. Thanks for the help. Kevin

try pressing both volume buttons and the menu button at the same time.

Hello & Welcome to FixYa

The problem appears to be with the door switch as initially it starts cycle and then the control senses open door so stops the unit completely. Take a hair dryer and blow some air on the door lock/switch assembly, if this won't help then replacing the door switch/lock assembly is recommended repair. Please get back to me if you have any other questions.

Kevin

Hello

This whirlpool duet front load washer needs a reset to resolve the control lock problem. Press and hold the END OF CYCLE button for 15 seconds to reset the control. Please get back to me if you have any other questions.

Kevin

try this:

Power the PC off, open the case cover, remove/reseat the video card in the slot.
* Power the PC off
* Disconnect the PC power cord from the rear of the PC
* Remove the computer cover
* Move the RTCRST (Clear CMOS) jumper from pins 1/2 and place it on pins 2/3
* Press the PC power button
* Move the jumper back to pins 1/2
* Remove/reseat the video card in the slot
* Replace the power cord and cover and then power the PC on

Hope it helps

Hello ,
Do you have / use a screen saver or have you set some power saving option in Control Panel's Power Options. Like turning off the hard disk after xxx amount of idle time?
Go to Control Panel >>Appearance and Themes >> next select Display >> look at Screen Saver tab.

Is it set to power off the hard drive after xx amount of idle time ?
Control Panel >> Performance and Maintenance >> Power Options.

Right-Click the My Computer icon on desktop. Select Properties.
Next, select Advanced. Look for a block that says Startup and recovery. Press the settings button.
In System failure section, turn off (un-check) Automatically restart. Apply change.

I would try a reset, then re-sync.
To reset iPhone, press and hold the Sleep/Wake button and the Home button at the same time for at least 10 seconds. During this time, a red "power off" slider may appear and the screen may go black, but do not release Sleep/Wake and Home buttons until the Apple logo appears.

If I could be of further assistance, let me know. If this helps or solves the issue, please rate it.
Thanks, Joe



I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_8b8c2cd6ce148309

Hello,

To solve this problem you must to use on your keyboard the key "F verr.f." near the "print screen" key. After lock it, you can used the ALT+Fx combination.

Enjoy

Try to do a reset by holding down the menu and select button together till the screen goes blank. The screen will soon pop up with the Apple logo and it will restart. If you can't reset it, then if you know how to take the back off, take it off and carefully prise up the brown lock on the power connector, release the power cable, then put it back and push down the brown lock to lock it in. Put the back on again and start her up.

hello kevin,
Please see the link below and contact the toll free number or online service agent.

http://www.us.playstation.com/Corporate/ContactUs

They must help you regarding you PS2 problem.

Thanks.

hello!

-- who is your internet service provider
-- what is the operating system of your computer?
-- is this working fine before or is this a brand new router

you may try this and see if this help solve your problem

Step 1: Shutdown the computer.
Step 2: reset the router while power on then Unplug the router’s power cable.
Step 3: Unplug the Broadband modem’s power cable and wait for 30 seconds.
Step 4: Plug in the Broadband modem’s power cable and wait for its lights to appear stable.
Step 5: Plug in the router's power cable once the modem’s lights appear stable.
Step 6: Power on the computer on and configure the router settings
Step 7: test the Internet connection.