Can not get signal no chanles

contact u service provider they will provide u with the settings u need .it will be LNB and frequency settings

ooh...check the wiring first to make sure it's connected well

You will need to goto a FTA site, like autorollbins.com or others and reg.

Have you done a blind scan on your receiver?

Hello Keithclu,
Sorry for the late response.
I'm afraid that there aren't any known upgrades to decode kryptoworks encryption, besides this STB has only 1Meg flash memory and can only be use to receive FTA signals.

Follow instructions here FORTEC STARLifeTime ULTRA Digital FTA Satellite Receiver

Hi,

To my knowledge all satellite receivers uses a dish antenna which is actually just a reflector. The actual antenna is incorporated inside an LNB (Low Noise Block downconverter). If you have already such a unit, then the issue might just be alignment.

This page displays some dish antennas as well illustrative alignment procedures.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards.

Thank you for using FixYa.

you have to find the new key codes

i have problen with receiver fortecstar lifetime not turn on i tryed to put a new bin but no working, i don't know what i can do it for fixing


raymond

you could j tag it go on some fta forums