I just bought my tv last week, and it seems like the color scheme is out of whack. People's lips and ears are much more red or rosy than normal, and sometimes it looks like you can see the color going in and out. Is there something within the settings I can change?

Does menu have any red? Yes = digital video bad; No is light engine bad.

It's very possible that they have produce a new formula. I would try to discontinue use just to be 100% sure that it is what's causing the negative reaction. It is also possible that you are newly allergic to something that has been there all along

Hmm, you have 2 possibilities that I can think of. First, if the picture color and brightness seem relatively normal, I would replace the CRT driver on the C board. This is attached to the back of the CRT via the pin socket. Second, if you notice a darker picture or faded color during the cycling period... things are not as rosy. This is a good indicator of a High GR (gas ratio) condition. Basically, your CRT is leaking.

You didn't indicate what type of connection you have between the TV and the PC. The basic color scheme is red-blue-green, so your tint sounds like it's missing the red. It could be a cable problem, can you try replacing it/them. Or it could be a problem with the computer. If you don't want to return it you could try a different video card. I'm assuming you are using the motherboard video drivers.

the problem is at the crt base .there r three red,blue n green o/put.verify if there is dry in the soldering n check the red cathode voltage it must b around 150 .if not then check the resistor that feeds the red o/put.it could b 12 to 15k. all crt have 3 driver color red blue n green,whenever one driver not working the color changes.that wat happened to ur tv now i do not know wat model u have.the drivers may b transistors or now its ic that r being used like tda 6103q.best of luck

Your TV probably has several different ways of connecting video. One is component, which uses three cables. They are red, green, and blue (RGB). The video output on your DVD player will match this color scheme.

Another scheme for video is composite (because it combines the red, green, and blue into one cable). Composite video is usually a yellow "socket". It is simpler to connect, but the video quality is noticeably poorer than component (RGB).

Another scheme is S-Video. This is one cable (round and black), but you will see four pins inside the connector (and four holes in the "socket"). This accounts for the three cables in the component scheme with the convenience of having only one cable. The picture quality is almost as good as component as well.

In your case, there may be confusion between composite and component. If you have red, green, and blue sockets on both the DVD and TV, then make sure you use them and connect them color for color.

Now for the sound, this is simpler. Red is the right channel, and white is the left. Make sure you connect red to red and white to white. Then, viola, everything will be right.

I hope this helps.

Symptoms of a Defective or dying Power supplies on LCD TVs.
1. Light(s) on the front panel are behaving not normal example, blinking, amber color or not steady, fainting, etc.
2. TV not turning ON properly.
3. TV turns OFF by itself.
4. Needs to be unplug to many times to make it work.
5. Humming or high pitch noise heard through speakers or at the back of the TV.

I repair these power supplies. Write to [email protected]

Convergence amp ic bad
http://home.earthlink.net/~oleg.filippov/ConvergenceFix.htm
http://cmpalmer.blogspot.com/2006/11/fixing-my-own-tv-part-ii.html
http://www.hdtvoice.com/voice/showthread.php?t=28929

If the convergence is missing in the menu in screens,you have a bad reg ic on the convergence power supply the part number is 215530,the power supply is located on the black plastic above the right module with all the heat sinks

May need higher quality component HD cables? Tried switching Blue on Red? Just some thoughts.