When I put in the disc for Let's Ride Silver Buckle Stables into my PC the installation starts fine. I go through all the steps and then when it starts to install it stops and tells me the installation has been interrupted. I've tried ten times but I got the same result. What's happening? How can I fix it?

The game may have a crack file in its installation disc.....try copying it to the game's directory........or search for its crack online........

windows 7 is no longer supported by Microsoft so there may be conflicts between the systems
put the disc for the game in a cd and go to computer and run the disc from the cd icon

Hey 1323164 you were right. I was having this same problem trying to run this game on Windows 10 but what ended up fixing it was opening up the folder on the disk, running the setup file in compatibility mode for Win XP (service pack 3), and running it in administrator mode. Then in the setup I ran custom install, and selected the Direct X install and selected "will not be available for program". Basically it would not be installed with the program. Then I pressed next and it installed and runs great! :D Thank you so much for that hint!

OMG I have the same problem!! I have tried to do various things on custom but it will not work. They say though, for some people custom DOES work. U just got to select custom instead of
Typical, then make sure that u do not install directX 9

This is a common problem with certain CDROM and DVDROM drives. The laser is calibrated to work in most conditions but when presented with an off color surface it cannot get through. Only advice I can give is to use only silver bottomed discs.

Try installining the game with administrative rights.

First see how much space the game takes up, then see how much free space the memory card has

You can normally unplug the sensor that is on the floor under the seat, either attached or close to seatbelt.

1. If there is an options program that you can run for the game, set the video resolution to something your monitor can handle.

2. Since few programs have that option, you may right click on the icon, select properties, and select compatability mode. Force the resolution to 640 x 480 and see if that helps.

You are getting this error because your monitor cannot handle the resolution that the program is requesting and it's out of range of what the monitor can handle.

The recover disc will be for a specific model. Can you post your model number please. Any other model's disc will start, but will fail when the model type is checked. Be specific about the model number.
Dan