Gas bravo serie 3000 dryer turns on electronically but then wont start any of the cycles

F-01 Means the main electronic control board is likely to have failed.

Unplug the dryer for 5 minutes and the plug the dryer back in. If the code reappears, replace the main electronic control board.

This is where I would start.

Maytag Dryer Circuit Board Timer Parts

Maytag Bravos 7.0 Cu. Ft. Electric Dryer F73 - Questions ...

www.fixya.com/search/p688923-maytag_bravos_7_0_cu_ft.../f73
have a bravo dryer , wont start shows error code f73 ? lights come on but dryer ... I think there was an F73 or F93 error message but we did not write it down.

Check for power first must have all the juice one side of electric can be down. check door switch or replace Dryer electronic control board Part #: W10222206

Sounds as if you have a clog somewhere. This is designed to stop running when it senses there is a back flow or resistance to the air pushing through here.

Most likely needs a new thermostat. Go online to find instructions on replacement. Make sure it is unplugged. I don't think it is too difficult to do yourself.

Bravos dryer manual

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Do you mean F-23?

Bravos dryer service manual



If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

this may help, Tim:

http://www.assuredparts.com/MaytagBravosDryerFaultCodes.html

People, the first words the poster said were that the dryer was "brand new". All of your suggestions assume the dryer had extensive use. This sounds like a factory defect issue!!!! My brand new Maytag Cabrio gas dryer is also making an obnoxious buzzing sound that seems to cycle on and off as the gas ignites. The buzzing sounds electronic not mechanical. What would buzz when the burner is active?

Older machines have problems with these coils.

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61