Euro-Pro Steam Generator G6200H iron

-Make sure dial or slide control switch to the correct position.
-Make sure there is water in the reservoir.


Good luck

Mai

ensure your iron steam button is not set into perminent steam function. leaving the iron with the point of the iron pointing upwards should reduce steam to the handle. also the iron may need to be descaled to ensure any steam switch funtion is not stuck in an on position.

call them directly 1-800-798-7398

Return it to the purchaser and they will replace it or return to the manufacturer. Be sure to take your reciept with you

your thermostats should be changed

I'm having a problem with a Euro Pro Steam Iron as well. Thier customer service phone number is 1-800-798-7398. Hope this helps

Hi,
Try using different water...

Here is a tip that will help you with that problem...

My Steam Iron is Leaking Water
http://www.fixya.com/support/r5301301-steam_iron_leaking_water

heatman101

I have a temporary solution that is working: Use WD-40 around the switch. Spray with the straw that comes with the WD-40. Let stand for a couple days, then turn the whole unit upside down and spray again, and let it stand that way for a couple days. If we could get inside, it could be more of a sure thing, but I had given up on mine and when I accidently hit the switch after siting for the last few days, , it came on!

tombowdb

Now for Sears to try to locate the tool that will open the case.

Sears sells a screwdriver set (47486 is written on the handle) that has a lot of non-standard drivers. There is one on there that will fit the nuts on this unit.

Also, I used a rubber tube from an Auto parts store to replace the cracked hose. I figured the Automotive hosing was designed to withstand the heat of an engine. So, it should work on this iron.

Bring the cracked iron hose with you to the auto parts store.

take down the iron and clean it the holes at the bottom of the iron are clogged up.good luck.