1. Power off machine. 2. Using a metal paperclip, insert it into left side of top needle. It must insert at least 1" deep. Insert it into slot on right side and again from back of needle. 3. Remove KCup cradle. Separate bottom from top. In the top section, insert the paperclip up into bottom needle from the bottom upwards. It will not go all the way thru and this is normal. 4. Reassemble KCup cradle and reinsert it back into coffee maker. 5. Power on machine. 6. Brew a cup of water only. There may be coffee grounds in the water and these should eventually clear during the remaining steps. NOTE: A large cup brew cycle should output a full 8 ounces (235cc). Less means there is still a blockage
My Keurig SS700 quit pumping water completely. I tried the de-scaling. Didn't work. I cleaned the needle with a paper clip. Instant fix. Now descaling. Thanks much Diceman51.
Glad it helped.
i cleaned it out with a paper clip and it still makes the sound and says not ready on the screen. it doesnt take any water out of the tank and then it turns off.
×
5,027 views
Usually answered in minutes!
hEAR SOUND BUT WATER DOESN'T COME THROUGH TANK
×