Error 3528, remove back cover..remove all paper replace cover. I followed the directions, removed the paper from the trey nothing seems to help. have reset, restarted and updated with no luck. I've had the printer about a week with no probs. Girlfriend removed and replaced the color cartridge then the error popped up.

Turn off the printer and unplug it. Open the top access panel. Inside on the left you will see three round, white gears. Rotate the gear closest to the front back and forth with your finger. If any scraps of paper appear near the rollers, remove them. Close the top access panel. Plug in and start the printer. This worked for a Kodak ESP 3.2.

Hello Shaheen,

Try this:

To resolve the error:

1. Press the On/Off button on the printer control panel to turn off your printer.
2. Wait 30 seconds.
3. Press the On/Off button to turn on your printer.

If the error continues, double-check that all paper and foreign objects are removed from inside your printer.
NOTE: Even if you do not physically see a paper jam, you will need to follow the paper jam link to solve the error.
Paper Jam Error

Sounds like there is a sheet of paper jammed in it. Try taking off the roller access panel in the back (not the access panel by the cartridges). Make sure to only use clean sheets with proper humidity level to avoid jams. Also fan the sheets before feeding to disperse any static.

get you a can of air and blow it out with that. then try it again, this helps with mine

There may be a small piece of paper in the back that is causing the sensor to give you the error message.

Printers give jam messages when a sensor is being blocked by and object.

If there is no paper causing this, you probably have a sensor problem.

Try unplugging the printer and plugging it back in.

I've got exactly the same situation/circumstances and error code, the thing different is that my code changes between 3533 and 3528? sorry I;m no help right now but I'll be back if I solve it. Martin. ([email protected])

Check the complete paper path very carefully, it only takes a small fragment of paper stuck somewhere to signal a paper jam. Also check that the paper sensors have returned to their normal positions. See that the printer has not picked up a second sheet of paper and this is somewhere in the path.

I have this printed and if you read (carefully) through the manual it tells you it doesn't like single sheets of paper. If ever my paper feeder tray runs below say 3 sheets then this error will crop up so keep it topped up with paper. The same goes for photo paper too.

Please follow the directions below to clear the paper jam error orincase there is one somewhere.

Turn off the Printer. Remove the drum and toner from the front cover. Remove the toner from the drum. Look inside machine incase of possible paper jam. Open back cover and paper tray incase of jam. Close all doors and put toner and drum back in machine. Turn on the printer, and see if the error message is gone.

The following is general advice that applies to removing paper jams in most printers, copiers, etc.

Switch off the printer at the wall and unplug it. Remove the paper tray from the printer. Check to see if the printer has an access door in the rear to allow you to see inside (open it). Open any other external flaps (eg. manual paper feed tray) that will allow you to see inside. Open any internal flaps or levers designed for user operation and usually indicated with a green or orange coloured tab.

Always remove jammed paper by pulling it in the direction of normal travel only. Don't try to pull it out against the direction that it entered the printer. Sometimes rollers inside the machine have a knob (usually coloured green or orange) that can be used to manually wind the page through the printer or fax. Always turn in direction of arrow indicated only.

After removing page, return all levers, flaps, doors, paper trays etc to original positions, reconnect power to the printer and test