Question about Dayton Heating & Cooling
I have Dayton propane wall furnace. (Its 20 years old). Last yearwe went through 250 gallons of propane in 14 months. (We use wood heatprimarily, and have small tank-less water heater). This year wewent through 250 gallons in 6 months, barely used heater. It hasa big yellow/orange flame, and there was all this very fine black sootin bottom. I knew enough to know that the oxygen /propane mix iswrong, and a repair man did a Carbon Monoxide test, which read zero, sohe said the heat exchanger is not cracked, and although there's quite abit of sooty buildup, he doubted the flue was blocked. Yesterday,I cleaned out as much soot from top of heat exchanger as I could, and ahome book suggested removing/cleaning burners, and adjusting 'setscrew' to change mixture of flame. The diagram in book lookednothing like the way burners are installed, and I was unable to tellwhat and if there even was such an adjustment for propane/oxygenmixture. I realize all the sooty ash could be clogging burnersexacerbating problem, but I believe the soot is a result, not thecause of the inefficient mixture. I did notice when I turned pilotto "off", it did not go out for over 10 minutes and I had to blow itout. Is there something else I can look for on gas/safety valveto adjust, or can you tell me how to remove the burners to cleanthem? (They are up even with pilot light, which is behind panel onheater/has a little hole for lighting, but difficult to even see burnersurface.) Repair man is coming back to test gas pressure at tank, atheater (with hot water running although tank-less water heater wasinstalled 3 years ago and seems completely unrelated to furnace problemthat started 6 months ago), said the diameter of gas line at tank maybe too small or too big (although its been fine for 20 years). Isuspect its the safety/gas valve but I have no manual...Any suggestions?
A clue to what could be wrong is that you mentioned it took 10 minutes for the pilot to go out. It could be your gas valve. Get a technician in to check your gas pressure both before the gas valve and after. Have them check it as the water heater is running.
Posted on May 16, 2008
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Tips for a great answer:
Mar 22, 2017 | Dayton Heating & Cooling
Nov 02, 2011 | Dayton Gas Furnace Heater
Jan 05, 2018 | Dayton Gas Furnace Heater
Jan 10, 2010 | Dayton Gas Furnace Heater
Jan 09, 2010 | Coleman Propane Forced Air Heater...
Dec 05, 2009 | Dayton (3E407) Heater
Oct 02, 2009 | Dayton Gas Furnace Heater
Mar 31, 2009 | Coleman Propane Forced Air Heater...
Nov 22, 2008 | Heating & Cooling
1,368 people viewed this question
Usually answered in minutes!