Programing pager tone alerts

It is most likely the encoder. It sends the signal to make the radios act like pagers. Two tone radios and pagers use almost the same exact format for programming. Has anyone worked on the base station or encoder? That is where I would start. Do you have the Vertex software and cables? It could be called a timing setting. This may not be a simple fix. Is there a service shop nearby? We've worked on pagers over 30 years and VX 231's for 12 years. They simply do not stop working unless someone adjusted something.

https://www.manualslib.com/products/Radio-Shack-Pro-2055-3809535.html

Yes - follow this link to an easier to read/easier to use manual that you can download and print, at no cost:
http://marksscanners.com/97/97.shtml

You can download and print an easy to read aftermarket manual for your scanner here:

http://www.marksscanners.com/97/97.shtml#receive_modes

For a comprehensive database of active frequencies and systems in your area, visit:

www.RadioReference.com

Bill B

Hi, my name is John. Just L/O the ones you don't want, then SCAN..hope this was helpful Please rats this solution on the thumbs four thanks John

The programming instructions are too detailed and lengthy to post here, so here's a link to the manual for your scanner. It will walk you through the programming process.

For an extensive database of active frequencies and systems in your area visit
www.RadioReference.com
or
www.CityFreq.com

If this response helps, please take a moment to post a rating. "Very Helpful" would be appreciated.

I would need to know more about your problem before i can advise you.

Hi. Radio Shack is good for a lot of things. Frequencies are not one of them. Go to the site below and you will find ACCURATE frequencies or "codes" as you refer to them. As far as programming that particular radio I would have to have it in my hands to program it. Good luck. http://www.radioreference.com/apps/db/

Good Day,

See this link for all available documentation:

http://support.radioshack.com/productinfo/DocumentResults.asp?sku_id=17-6020&Name=Pagers&Reuse=N

Hope this helps

under zone edit change your optional signalling rules to qt dqt and optional signalling then the radio will only hear when all rules are satisfied ie right pl tone and decoded two tone make sure yoou only turn on optional sig on the page channel