The restiance isnt working properly, no matter what setting i put it on.

broken ring, valve stuck open , burnt valve or if it over 5 hp then pull it harder as it is the decompression part of the cam working

If all your wanted is to widen the picture then just push aspect or format on your remote control and put it on either 16:9 or full. But if your referring to HD then an HD picture fills the screen by itself no matter what setting you have the tv set to. If the screen isnt full then the program your watching isnt broadcasting in HD at that time. A common misconception is that because its an HD tv or an HD channel that it always should show in HD. This isnt true. It goes by the broadcast

your spinner might not be working. try cleaning it. and if it isnt your spinner, try cleaning your laser.

try doing a colling system flush ,if that doesnt help replace the waterpump!!!

Is the fan running or do you have an electric fan? If fan isnt running or never comes on no matter what you do it will never run much cooler. If fan is good then you could flush the radiator a couple of times and that will help but if fan isnt working it wont last long

The issue lies in the glass fiber wire, the wire is coated with a conductive metal only a fe mircons thick.

Simply put the headset is a poor production model, the use of glass fiber wire more often than not results in a short in the wiring. Thus the sound will come out of one side, not at all, etc.

no just go to settings on the game and configure your guitar drums ect.

okay could be you computer isnt set up properly for the HD

is this and internal HD or external??

your jumpers could be set wrong on the HD

you just dont put a HD into a computer without setting the jumpers properly



I’m happy to help further over the phone at https://www.6ya.com/expert/david_92c86cbc79e9b552

Are you pressing and holding the button and does the system still power on and off alright? If the system still works properly then it isnt a huge concern. If it wont power on or off then do an exchange at Wal-Mart.

hi if you got a voltmeter TEST IT ALL ON A LOW LEVEL OF VOLUME!! check the outlets of the amp if there is a signal at all... no? - the amp isnt hooked properly! yes? - check if the volt level on the outlets is higher then the level on the inlets of the amp (the amp is amplifying) no? - the amp isnt hooked properly! or its bad... yes? - connect a speaker to see if its working wont put out a lousy spark? check your system, the problem if probably there... check all the connections, fuses, wires begin from battery and go FWD antill the next device isnt working good luck