The range is tellimg us that the touch pad needs to be replaced. Do I have to go through a dealer or can I buy one online.

Hello,

Here is what my online service manual for the F2-EO error code says


F2 - E0 Shorted keypad (also called touch pad) 1. Check keypad connector for firm connection (keypad connects to control board).
2. Press CANCEL. If error code returns after 60 seconds, replace keypad (also called touch pad or membrane switch). Some models incorporate keypad in to control board as one unit. In this case, replace control board (also called ERC or clock)


I hope this helps

Gene

Hi,
That is not that hard to fix and you can easily buy the parts yourselfonline...

Here is a tip that will help you with the online buying...

How to Buy Appliance Parts Online

Here is one site that I recommend http://ping.fm/zJDAM
heatman101

Hi,
That is not that hard to fix and you can easily buy the parts yourselfonline...

Here is a tip that will help you with the online buying...

How to Buy Appliance Parts Online

heatman101

F1 Stuck touch pad Usually means that either the touch pad or the oven control (also called clock or ERC) is defective and needs to be replaced. If this fault code cannot be cancelled, replace the oven control (also called clock or ERC), touch pad, or both.

You have a bad membrane touch control. Check your owners manual for warranty on the electronic control. If it is out of warranty you need to call an authorized LG service dealer for a quality repair.

Your key has a programable security micro chip inside it. It is either and embedded chip or a transferable one in a **** shell type key.
Some dealers may have generic blanks and cut them to code with a laser cutter. If it is a **** shell type key with touch pad buttons, they simply reinstall the touch pad when equipped. If not the new key must be programmed to the cars security system
There are online sites on ebay, including one in Florida who gaurantees his work and genuine parts, but I would strongly recommend against a generic key online.

Defective touch pad or clock (ERC) Replace touch pad or clock (ERC). Touch pad is a more common problem. Refer to F1 test at the top of this page for more information.

Function key shorted or stuck :
Replace touch pad or if touch pad is part of the clock, replace the clock (ERC).


F1 touch pad / ERC test This simple test will help determine whether the ERC (Electronic Range Control or Clock) or the touch pad is defective when F1 error code is present.

Note: Some models incorporate the touch pad in to the ERC as a single assembly, in which case this test is not necessary. Simply replace the ERC (Clock).

Warning: If you feel in any way uncomfortable performing this test or making this repair, please contact a qualified appliance repair technician.

1. Disconnect power to the range (unplug the range power cord or turn the power off to the range at the circuit breaker). It is very important that the power to the range has been disconnected, so please double check before continuing.
2. Gain access inside the control panel.
3. Disconnect the touch pad (also called keypad or membrane switch) ribbon from the ERC.
4. Make sure there are no lose wires, or anything else that may cause a short when power is turned back on. Assemble the control panel back the way it was.
5. Turn the power back on.
6. Wait for at least one hour to see if the F1 code comes back (usually accompanied by a beeping sound).
7. If F1 comes back, replace the ERC. If it does not, replace the touch pad.



If you need further help, I’m available over the phone at https://www.6ya.com/expert/craig_3fa289bf857b1a3c

put on tree belt . having the same problems replaced ERC $200.00 now they are telling me touch pad touch pad is $240.00 .the stove cost $1300.00. $1740.00 how much more will i have to put in this stove