I cleared a paper jam in my hp psc 2210 but can't remove "Paper Jam" instructions from desktop. "Cancel and Heop" are not responding even though I have run some copies.

most probably there's still a bug, insect or just a small piece of anything caught between the roller or wheel after you cleared a paper jam otherwise a spring, hook tension-er across the roller is not in-place.

Check door for paper stuck in front of sensor. There is a door in the back look to see if paper shred is in there infront of the back door sensor.

off ur printer then clean paper pickup roller

Paper jams can be tricky to solve. The paper is usually stuck inside the printer mechanism so even if there is no visible paper jam, you will still get the paper jam error. Try this:

1. Turn off your printer
2. Open all trays and remove any paper stuck there
3. Locate the button to open the printer, open it and remove any paper stuck there also.
4. Repeate the above step for all buttons that you can find to access the inside of the printer
5. Close all doors and put back all trays
6. Turn on your printer

NOTE: Please rate our help to keep this free service online.

You can't I have the same printer and it is the stubbornest thing in the world. Just hit enter and keep printing.

Please work through this article first. If that doesn' t work follow these instructions to do a partial reset., or use these instructions to try cleaning the rollers and make sure they move freely.

I hope this information allows you to resolve this issue. If you need further assistance, please post back with a comment to this thread.
If I've managed to answer your question or solve a problem, please take just a moment to rate this post....thanks!

This is almost certainly a broken latch on the right of the carriage - it should get pushed forward by the left back edge of the cartridge mechanism as it reaches the right side. There are other examples of this described in many similar posts on various sites - including some with photos. Try and find another psc all-in-one and look at it. I have the same problem, and have 'mended' the latch so that the paper error disappears and it prints, but I have not yet solved the loud clicking
Richard

For carriage jam try these steps

Remove both the ink cartridges from the All-In-One. also all the papars in the tray
Unplug the power cord from the All-In-One as well as the power outlet.
Now move the carriage (carriage is the one which holds the cartridge) Too and Fro till you feel the carriage is moving smoothly.
Then insert the cartridges close the access door.
Plug the power cord directly to a wall outlet without surg protector.
Before connecting the power cord to the All-In-One press and hold the # and no 6 button and then insert the power cord, do not release the keys
until you see a message a reset (if the screen goes blank then release the keys and turn the power on)
Now try printing a test page or make a copy

Good Luck

Please try the steps mentioned in the link bellow:

http://h10025.www1.hp.com/ewfrf/wc/document?lc=en&cc=us&docname=c00042573&dlc=en&product=79499

Good Luck

Check
http://h10025.www1.hp.com/ewfrf/wc/document?docname=c00265823&cc=nz&lc=en&dlc=en&product=422000&dlc=en&lang=en

"

HP PSC 1600 and 2350 Series - Paper Jam or Paper Feed Problems"

When the all-in-one detects a paper jam, the following message appears: Paper jam: Press OK to continue . The computer might display the following message: There is a paper jam (or misfeed). Clear the jam and press the Enter, Resume or OK button on the HP PSC. This document will assist in correcting paper-feed problems such as paper jamming, print slanting, and multiple pages feeding into the all-in-one. Clearing paper jams