Nokia 7610 - MMC Password

may be ur mmc memory card was busted. why not try to replace a new one.

hey my nokia 7610 has 4 buton no work what can i do?

udah coba pake memory laen? bisa jadi mmc corrupt.tapi klo pake mmc laen tetep hang permasalahanya ada di IC MMC,solusinya dengan mengganti IC MMC tersebut.moga membantu.

mmc damage

firstly dont insert your mmc back in it and then try to hard format it.

try with this *#7370# and after it gets formatted then just switch off your cell phone and then when your phone gets completely switched off then press and hold the send key (green) and while holding the send key press * (star key) and then number pad key 3 (three) hold them simultaneously and switch your cell phone back on and keep holding those keys till it shows FORMATTING,,,,,,,,,,,,,,

i think your problem will solve with this.
then you can insert your MMC and format it.

i want software for remove password from phone's memory card.i kindly requesting.

RESETTING PHONE BY NOKIA SECRET CODES (steps 1 and 2)

1st step : SOFT RESETTING NOKIA MOBILE
Take backups of ur phone books,calender and others, then simply enter the code
*#7780#

2nd step : HARD RESETTING BY CODE
Just enter the code-
*#7370#
Then it asks for security code enter ur security code whose deafault value is 12345
NOTE:
The battery must be full or the charger has to be connected to the phone so that it does not run out of power and make the phone unusable.
Take backup of the contacts and other important data in MMC .

FLASHING

3rd step :FLASHING : ANOTHER METHOD FOR HARD FULL FORMATTING

This step is known as flashing of phone. Always do this step at last (after 1st 2 steps are over and u are not successfull)

1. Make sure you phone is fully charged. (At minimum 3/4 of bettery should be left)

2. Backup your contacts list and personal files to MMC memory card (if possible).

3. Switch-off your mobile phone.

4. Press and hold these three keys together

-Green dial key,-Star key (*)-Three key (3)

then press the power on/off to swtich on the 6600 phone.

Do not let go the three keys until you see the “formatting” screen displayed

5. After a few minutes, the format will be complete. Your mobile will now be at its original factory settings (It will reach the same state as that in when you purchased it)......................enjoy



Regards :
dilipbagdi
Technical Associate

Full phone formatting on a 7610!

If you encounter situation like below on your 7610,

1. Blank screen phone unable to reboot.
2. Phone only able to boot-up to "Nokia" word screen.
3. Install some program but not able to uninstall it after that.
4. Error messages such as "Child Installer" keeps popping-up.

Do a Full phone formatting on your 7610! as steps below,

1. Make sure you have at least 3/4 charge of battery power left.
2. Backup your contacts list and personal files to MMC memory card.
3. Switch-off your 7610 phone.
4. Press and hold 3 keys;
Green dial key, * (star key) & no. 3 key and then press the power on/off to swtich on the 7610 phone.

Remember, do not let go all of the keys and hold keys until you see a formatting word screen show!

5. After a few minutes when the Full phone formatting completed, your 7610 will back to original system and factory settting.

All apps installed & not of the phones' default will be lost. If you did a backup on your mmc, you can restore it back to the C drive again.
Thank you for rating this Tip

hi

you need to bring that to a cellphone service center since you cant either go in thru safe mode right?

that may have been due to a corrupted application you had installed. the only way for your phone to be used again is to bring it to a service center and have it reset.

hope this helps.

What should we do if we forget the password? For S60 1st and some of 2nd phones, such as Nokia 3650, Nokia 6600 and Nokia N-Gage, the password is stored in a plain text file.

• Firstly, you need to install FEexplorer, a free file manager that allows us to browser through S60 file system.
• Next, launch FExplorer and then browser to c:\system folder. There is a file, called mmcstore.
• Rename the file to mmcstore.txt and then open it. Your password must be several characters at the end of the file.