At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The timing circuit may be defective and the circuit board needs replacing. Have an authorized serviceman do a continuity test on the board and have it rest to factory specs.
TRY A RESET CODE
Press the "Sani Rinse," "Heated Dry," "Sani Rinse" and "Heated Dry" buttons on the dishwasher's electronic control panel in quick succession to put the appliance in diagnostic mode.
Close the dishwasher door and engage the door latch.
Wait 10 seconds before pressing the "Cancel" button to reset the dishwasher.
press normal heated dryer normal heated dry normal the dishwasher should reset and start. You will need to check the heater this happens because the heater normally fails. Let me know,
Hello there:
It doesn't work at allIf your dishwasher doesn't work at all, check
these:Door
switchWiringTimer
or selector switchPower from the houseIs there power getting to the dishwasher? This can
be difficult to test, because dishwashers are usually wired directly to
an electrical circuit, rather than plugged into the wall. But at least
check for a blown fuse or a tripped circuit breaker.Door switch
The door switch is important because, if it's
defective, the dishwasher won't work at all. To reach it, you need to
remove the control panel cover, or sometimes the interior liner of the
door. If it's defective, you need to completely replace it.
WiringOften the main wiring connection from the house,
at the dishwasher, burns and breaks the connection. If that's the
problem, the wires must be repaired/replaced as necessary. If that's not
the problem, check the wiring to the door switch, the wiring between
the door and the lower part of the dishwasher, and the wiring to the
timer. Repair any broken, burned, brittle, or defective wiring, using
the proper appliance-grade wire and connectors.Timer or selector switchAlthough it's uncommon, the timer or the selector
switch may be defective. If so, you need to replace the defective part,
because neither of these can be repaired.
×