SOURCE: blue shadow
Needs convergence circuit repair = replace convergence IC's,
then activate Magic Focus...............need step by step?......T.
SOURCE: HX-P4241W appears yellow. Left and Right of screen are yellow
Yellow is the lack of blue. It can happen when you are running your contrast - which is your overall light level - too high.
Try turning down your contrast. On CRT tech, contrast should always be run at half what the factory allows as full, on the user controls. Full up is what calibrators call Torch Mode, and is NOT the way to get performance to be in the linear operating range of CRT tech.
If your sides are more yellow than your middle, your set may need lenstriping. Mild yellow on the sides is not uncommon, and usually not noticed. But heavy yellow on the sides would indicate that the blue image needs work on white field uniformity.
Yellow is the lack of blue, in CRT tech.
Mr Bob
SOURCE: blurry.....convergence problem???
I agree with Shuttle83,
except with point #4 and #8,
#4 If you buy OEM Sanyo IC Convergence chips ruff looking black with rounded corners and up them to the next one up they will last longer. if you buy generic shiny smooth black with sharp corners they may only last 5 months. remember you get what you pay for the OEM's are usally $12-15 each, generics are $7-12
#8 you should reset to the factory settings after replacing the Convergence ships before trying to adjust again.
good luck!
95 views
Usually answered in minutes!
×