My's meg light won't turn on after replaced the battery, what do i do now?

during the battery replacement did you manage to either forget or damage a wire that powers up say your ignition module... ?

call a hd dealership to disarm the alarm . start there.

Hello, If the battery won't charge and the laptop won't turn on but the ac adapter works with other laptops, then the problem is the port where you plugin the ac adapter. Some of the laptops has it built in to the motherboard. So you might need to have it repaired by a technician. Or if the laptop is still in warranty, you might need to send it to the manufacturer to have it repaired or replaced. But if the laptop works without the battery, or it will turn on but the battery indicator is not lighting up, you're facing one of these problems. 1. The battery itself is dead. 2. the battery bay is loose 3. the battery itself is loose Hope this helps

http://www.chargerbuy.com/laptop-ac-adapter/toshiba-ac-adapters.html

When you say no spark, are you talking about the spark plugs, or just the general wiring?

If the engine won't turn over, then it isn't moving, and if it isn't moving then you need to check the following in this order:

1) Does the battery have power i.e. around 12.4 volts or over?No? Charge, test or replace battery.

2) Do the car's head lights dim considerably if turned on when attempting to crank? Yes? Possible lack of battery charge or faulty battery.

3) Assuming the battery is fine, can you turn the dash warning lights on and off with the key? No? Faulty ignition switch.

4) Is there a click sound when you turn the key, but no starter motor spin? Check starter motor connections or replace starter motor.


If none of the above prove to be of help, then please report.

call your dealer

Hello,
If the battery won't charge and the laptop won't turn on but the ac adapter works with other laptops, then the problem is the port where you plugin the ac adapter. Some of the laptops has it built in to the motherboard. So you might need to have it repaired by a technician. Or if the laptop is still in warranty, you might need to send it to the manufacturer to have it repaired or replaced. But if the laptop works without the battery, or it will turn on but the battery indicator is not lighting up, you're facing one of these problems.
1. The battery itself is dead. 2. the battery bay is loose 3. the battery itself is loose
Hope this helps...

If the engine won't fire up, but your starter turns over, you may want to check your timing unless you have a check engine light on. If the CEL light is on, have the codes scanned.

If the engine won't turn over with the starter or it clicks, have your battery tested at autozone or advanced auto parts. Replace the battery if it is bad. Else, have your starter tested.

If the engine still won't turn over and the battery and starter are tested fine, you may have a blown fuse, bad ignition switch, or a failed relay.

If the engine fires up but randomly dies and starts back up, you either have a failed sensor, failing fuel pump, clogged fuel filter, bad plugs or wires, or a failing ECU.

I’m happy to help further over the phone at https://www.6ya.com/expert/jeremy_69f3cc28d95bf514

Please DON'T CRY !

You may have bought the wrong modules. You may think they are plugged in right and not. Is there a beeping sound? How many memory slots do you have?
Are you plugging in just one stick? You may need to put in pairs. Put in the older 1 meg strips and make sure she still boots. You cannot mix 1 meg with 2 meg on a single bank. there is a Bank A0 A1 B0 B1 - make sure to put same in A's and same in B's. I know you will work this out, but make sure your motherboard can accept 2 meg Dimms ( DDR2?)

Are you sure the FREELEVER is in the right position ? , to test try to push the scooter ?

Battery Low ?