At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
Unable to get wind speed and gusts readoutsUnable to get wind speed and gusts readouts
AnonymousMar 24, 2014
As simple as it may seem, I cannot get the clock face to change? What am I doing wrong??As simple as it may seem, I cannot get the clock face to change? What am I doing wrong??
You can't post conmments that contain an email address.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Steve, thanks for that info on the reset button , I go through this every time I change batteries. I put a note on the back of my Springfield temp now.
Hi, Jackie.
Is it look like this ?
With Windspeed and 3 station temperature reading ?
If so, model number is 91751
Good luck with finding Manual.
I have paper manual with me, I can scan most useful pages for you (Buttons)
The outside temp for the inside reading quit working this morning when I went to check the temp.The outside sensor was working fine. What do I do to get the inside one to work again. The other features were working fine.
Press the M button (mode) until you get to the time. Then hold the S button (set) for about 3 seconds or until it starts blinking. Then you can use the up and down arrows to change the time. Once you are finished you can press S.
I'm not sure if we have the same clock. Mine has needed batteries for a while, finally picked them up today. Once the batteries were in I had to reset the Zone by pressing and holding "CLK/CAL" button until the time blinks, then release and push the button until you see one single number on there... then set the zone. There is info in the user's guide (I can't find mine) so I kept changing until the time was correct. Now works perfectly.
Unable to get wind speed and gusts readouts
As simple as it may seem, I cannot get the clock face to change? What am I doing wrong??
×