I have a kenmore washer model 110.82467800. It won't drain or spin. It does everything else but it won't drain or spin.

If the lid does not lock the safety controls will not allow a spin. Look for a broken lid lock - either the lock assembly or the small latch finger that inserts into the lock.

With no model number there is no way to be more precise. Sears Kenmore is sourced from more than one supplier (manufacturer) and there are literally thousands of models over the years.

sounds like maybe drain filter is plugged and unit is not draining fast enough. if you have drain access in front pull it out and clean it.

try this
http://forum.appliancepartspros.com/washer-repair/345592-kenmore-90-series-washer-wont-agitate-spin.html
Kenmore 90 series washer won agitate or spin Appliance Repair Forum

387780 does not seem to be a valid model number.
If you can locate the model number enter it here at sears Parts Direct.
Parts for Brands Craftsman GE Kenmore Whirlpool and more

Link to videos about washer not spinning.
top loader kenmore washer won spin YouTube

If wash cycle operates and water drains as should before spin indicates motor spinning. Chances are bad timer If your a real fixer you can remove timer control from panel check and clean all contacts internally making sure none are stuck closed . (Have had 3 110s in my time).not easy but can be done or buy new about 150$ reassemble and check operation.

Check door switch: If the lid switch is bad it will not drain or spin. Try this test: With lid open let it finish wash cycle. Press lid switch down with screwdriver. Washer should begin draining. Release switch. Motor should stop. Press switch a second time. Washer should start spinning as it continues to drain. If motor doesn't come on while lid switch is pressed, replace the switch. OR
http://www.youtube.com/watch?v=q942xn_2VXY
Click if helped.

What is the model number of your washer? This condition is caused by a bad lid switch.

Look for a blown capacitor if the other components are all fine.

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Hi tragz,

If it can't drain, it won't spin. There may be something preventing the pump from draining in the Pump filter. You will need to clean it.

Please follow my below Tip on how to do it:

ACCESS, DRAIN & CLEAN THE DRAIN PUMP FILTER

Kind Regards d")

* If this solution helped you, please rate it

First, see the Sears parts site for your washer:
http://www.searspartsdirect.com/partsdirect/index.action

Enter your model number (###.######) and you'll see a list of major sub-components with diagrams and parts.

Without a complete model number, I'm guessing but usually, washers have a lid lock built in that prevents the washer from draining or spinning unless the lid is closed.

If the lid lock is defective, the washer probably won't go into spin mode.

Check yours for the lock, where it attaches and replace it. It's probably not too expensive.