Triumph-Adler 4035 Firmware

http://www.fixya.com/support/t24309309-triumph_adler_dc_2018_error_c6000


Triumph adler DC 2018 error C6000 Kyocera FS 3900DN Laser Printer

Defective Fixing Unit... Poor contact in the thermistor connector terminals, bad thermistor, broken heater lamp wire or some other contact problem related to fixing section. If it is possible, check with another Fixing Unit.

Sounds like a Engine firmware failure. The clue is the low page count (the 00007).
You will need to upgrade your firmware and contact your local Kyocera sales comany to get a patch to correct the missing serial number and MAC address.

Will just reflashing the firmware fix this?

I have replaced the EEPROM (as per my post near the top) on a few of these, so that the printer will come to ready and then flashed the EEPROM via parallel port with upto firmware.
skyp techbelkin

Please get the correct driver here : www.printcountry.com/drivers.asp
www.opendrivers.com/.../printers-free-driver-download.html
www.driversdown.com/driverslist/r_4_1.shtml
Regards, Jay__jy764e

change paper size from printer properties maybe the paper size is LTR so you have to change it to A4

Try a new bottle. I've seen where the there's enough old toner clining to the sides of the bottle that prevent the sensor from seeing through it. Of course the sensor and led may be covered with old toner. Get in there with a vacuum when the machines off and clean it out.

Right click on the printer icon and choose properties. Your emulations are listed there.

0150 - Engine PWB EEPROM error. Detecting engine PWB EEPROM communication error.

Solutions:
1. Switch the printer OFF; unplug the power cable; wait 20 seconds; plug in the power cable; switch the power ON, If the error comes back follow the next solutions:
2. Update / Burn the latest firmware version. You may need to call a Kyocera Service Provider because you need a CF card (compact flash memory card) and the FIRMWARE.
3. Replace the Engine PWB (a board) - again you have to call a Kyocera Service Provider.

It needs a firmware update, very common, it would most likely be under warranty, if not post email so I can give you the firmware update required and I will instruct you on how to upload it to your quality printer.