Frigidaire front load washer will start to fill,3 or 4 seconds then stops,it will do this a couple of times and it just sits there I replaced the electronic control board,any other help,Thanks Marvin
Check the water level fill sensor. Some used to be pneumatic tubes connected to a sensor. Your washer may have a different type of sensor. It seems like it fills ant gets to a point where it expects the fill sensor to trip but instead just stops. Also re check ALL connections to main drive motor.
Also verify your mains power can handle the draw of the rated wattage. When it goes to engage the main drive motor it may not have enough current from the mains and simply stops.
Also check that the connection to the tumbler drum is not frozen.
5,751 views
Usually answered in minutes!
×