How to re-assemble the trigger assembly and trigger spring in the receiver of a daisy model 25 air rifle.

Question edited for clarity.
Question moved to a Daisy category. Please always include the model.

You need a set of o-rings and seals for it. Try Pyramid Air.

Pyramyd Air ' Premier Online Airgun Store

Pyramyd Air https://www.pyramydair.com Check out these great deals on air guns, airsoft, pellet and bb guns and accessories. This is your one stop shop air gun mall. Get yours today!

Air Rifles

PCP Air Rifles - Spring Piston Rifles - Gas Nitro Piston Rifles

Air Pistols

CO2 Pistols - PCP Pistols - Spring Piston Pistols - Gas Piston Pistols

PCP Air Rifles

Umarex Gauntlet - AirForce Talon SS - Hatsan Flash QE - ...

Air Rifle Accessories

PCP Accessories - Air Rifle Silencers - Parts - Stocks & grips
..

Question edited for full 'make model (what it is)'.
Question moved from Garden to a Daisy category, albeit a rifle.

Video here

https://www.google.com/search?q=daisy+5501+rebuild

There are some parts schematics but not yours.

https://www.google.com/search?q=daisy+powerline+5501+parts+diagram

,,

Videos, parts lists, and parts schematics

https://www.google.com/search?q=reassemble+the+trigger+on+a+Daisy+late+40s+Model+25+air+rifle

..

register and join this daisy gun forum
How to rebuild 1938B Red Ryder

My wife gave me a sixty nine year old Daisy Model 25 for Christmas and it was missing a trigger spring. Finally found the time to do so and it's always an adventure to find old parts.

Thought I would share something I learned from the Internet on how to install the part. Without the proper guidance, it can be a nightmare. Here is the easy solution:

Take the trigger assembly out of the gun and slip the trigger spring in behind. Short end fits in a space behind the hammer/sear; coiled section fits in the space just below. Here is the secret: take a piece of dental floss (waxed is better) and make a small hangman's noose on one end. Use the index finger of one hand to compress the hammer/sear while using the same hand thumb to compress the long end of the spring against the back of the hammer/sear. Slip the noose around the end of the hammer/sear with the long spring, pull the noose tight, wrap it around five to ten times (no need to tie it off--should hold by itself). Now you can install the trigger assembly back in the gun. Hammer/sear is already in the correct position below the installation screw. Snip the dental floss with long nosed scissors or cut with a knife blade. Any excess can be removed with tweezers.

Sounds tricky but it is actually much easier than expected. Takes a little bit of coordination to hold the compressed spring and hammer/sear while slipping the "noose" around the end, but it is worth the effort. Far better than trying to jam the spring behind the trigger already installed in the gun. Less chance to pop out into an eye or lose it as it flies across the room.

Hope this is helpful.

i was cleaning a daisy power line 922 my brother in law had for years cleaning out dirt and mud a spring came out of the trigger area and i dont know where it goes

HI, I found something on amazon. here: Crossman Air Guns Model 760 Pumpmaster Owner Manual English spanish... . I hope I have helped. cheers