Replacing Batteries - Computers & Internet

try replacing the batteries again and make sure they are in correctly-ive put them in more than once and found out it was the brand new batteries that were bad and also installed them incorrectly too

If there is no light coming on when pressing a button , the remote might need to be replaced.

replacing the batteries require the unit to be off.
Doing it live is not the right way to do it.

the unit does not sense the new batteries if running while the replacement is made.within 24 hours it will recheck the batteries...

Make sure the Fuse is ok also on the battery harness

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/lisa_52daba487e5b4d53

Make sure you are using name brand high quality batteries and not some generic from China. Camera require a great deal of power to boot up.

You have either put the batteries in wrong or you have lost programming, see the dealer if you are 100% sure the new batteries where not installed incorrectly. What about the spare key???

The most likely culprit is that you are out of battery. Try replacing or recharging the batteries. If you try this and no luck, you may need to purchase new batteries. Even rechargeable batteries need replacing over time.

Hope this helps!
Good luck!

The batteries you used as replacements may be to weak. Try replacing the batteries again, with new ones out of a currently dated package.

There is no instructions.Remove the cover nut's and keep those carefully.u can remove battery cover after that.

After replacing the transmitter batteries several times, I tried replacing the clock batteries. They must have been getting low. Once I put in new batteries in the clock it worked fine. Good Luck.