I have a question regarding my 630-1015 WX-200 Wireless Weather Station. How do I empty the rain gauge if I have installed it on the roof?

Question edited for clarity, two questions made into one.
Question moved from Digitech Music to Weather Station
Duplicate post deleted in Cars and Trucks. Refresh page to see your question published.

Help in the link. All of the weather stations are made by the same company.

https://www.google.com/search?q=calibrate+a+Digitech+rain+gauge

..

Have you tested the rain gauge using the calibration procedures on page 21 of the manual? Specifically confirming that the bucket is emptying about every 25 drops.

https://www.acurite.com/media/manuals/01536-instructions.pdf

I assume it is a wireless station. If so, there is a procedure to go through to get the temperature sender and the base station to sync up and work. You need to check your owners manual to get the exact procedure for your unit. On my station, I have to remove the battery from the base station, let it power up and within 5 minutes, install the battery in the remote station(s) (temperature, rain gauge, wind gauge, etc.). Also, you must keep the remote station within a certain range for the base to get a good signal. Probably 25 feet, but the owners manual will have the right number. Also, use new batteries.

NATIONAL GEOGRAPHIC 331NC Manuals

I have the same problem and would also like an answer to this

http://www.plowhearth.com/product.asp?utm_source=shopping.com&utm_medium=comparisonshopping&utm_campaign=default&r=shoppingfeed&pcode=12487
64657

Oregon Scientific has an FAQ webpage for your weather station:

http://us.oregonscientific.com/service/faq.asp?t=1&cid=2

There are several Q & As that are pertinent to your problem.

I hope this helped you.

Good luck from Detroit, MI.

WX is for weather. If you put it on WX, and you do not hear anything, then you need to change the weather station it is on. in wx mode, you change weather channels by pressing channel up and down. To communicate with 2 way, press the cb/wx button so it is on CB mode.