I am looking for a cirit board for a endex DCMD67 for a bodyfit treadmill.

I can't help you (directly) with the resistor value, but be aware that if it exploded, there is probably another bad component (such as a capacitor, transistor, and/or an SCR). Replacing only the resistor may result in the same problem, or may not even work at all due to another bad component. If you do find out the value, try putting in a resistor of the same value, but with a higher wattage rating. I once had a washing machine in which the model had a known problem with circuit boards blowing. I solved it by replacing a bad transistor and installing a higher wattage resistor that had blown up like yours. It never failed again. The way I found the value of the blown resistor is, I looked up a replacement board online, then magnified the photo, and looked at the color code on that same resistor in the photo. How I found the bad transistor is too complicated to explain in few words, but you can google the procedure. (You'll need a multi-meter at the very least; preferably _with_ a built in transistor checker. However, a _totally_ blown transistor can be found with only the resistance settings on a regular multi-meter).

Best of luck...

This sounds like a Bodysolid brand machine - you can contact the MFG directly at this number

TECHNICAL SUPPORT
Available M-F 9:00am to 5:00pm CST
Toll Free - 800-556-3113
Fax - 708-427-3598

Hello from Greece!
If you see the red led (D1) on when you press the start button on your treadmill you have a short-circuit on your 20N60 transistor. replace this transistor and your DCMD67 circuit board will be new! but be careful, if this happen on your circuit board, In about 90% you must have problem with your treadmill motor or your treadmill belt.
If you have any other question just mail me.

Have a great day!

Hello I have problems with my treadmill when turning on the button of star passing the 3 seconds is heard hears the change of the relay and the treadmill does not work after a time out error in the lcd of time that is due to this

Hi, on the DCMD67M the motor run for short time (less than 1 sec) and stop and the error led (red) turn on, P1 displayed on the screen. What is the problem. Thanks

Go to the 2 next web page:

1) this is free:

http://fitness.manulsonline.com

2) In this you must pay.

www.fitnessrepairparts.com

sincerely. G-d bless you.

E.CUADRA
MANAGUA, NICARAGUA. C.A.

Dear Sir:

Thank you by your request, I will help you right now.

Please go to the next web page:

www. fitnessrepairparts. com

They sell everything for Fitness equipment: Electrical Parts+Electronic Boards+Mechanical Parts+ User +Service Manual+Schematic electric and electronic.

Of course you will pay for to buy anything. Do not waste your time Go ahead !

Thank you in advance, sincerely. GOD BLESS YOU.

If you need further assistance, please contact me.

E.CUADRA
MANAGUA, NICARAGUA. C.A.

Dear Sir:

Thank you by your request, I hope everything is fine.

I will help you inmediately.

Please go to the next web page expert:

www.fitnessrepairparts.com

You will find any Parts Electronic(Circuit Boards+Electrical Parts+Mechanical Parts) Manuals+Schematics, etc.Of course you need to pay for to buy everything you need.

Thank you in advance, sincerely. God bless you.

E.CUADRA
MANAGUA, NICARAGUA. C.A.

Call Body Solid @ 1-800-633-1227 ext 520 thats Parts and Tech support