For ventilate:
When it says to ventilate, it is asking you to prime the pump. Put acup under the panarello wand ( the steamer/frother) to catch thedischarged water and press the hot water button (upper left button onmy machine). Wait until air stops coming out with the water, usually3-5 ounces, and then press the hot water button again.
You machine is now ventilated (primed) and should be ready to go.
For decalcify:
Recommend downloading and following these directions.
http://www.partsguru.com/user/Safe%20Descaling%20method.pdf
Hi,
Try to make a cup of water ( like you do tea), if it not work then you have to replace the magnetic valve inside the machine
SOURCE: my coffee machine says "ventilate"
When it says to ventilate, it is asking you to prime the pump. Put acup
under the panarello wand ( the steamer/frother) to catch thedischarged
water and press the hot water button (upper left button onmy machine).
Wait until air stops coming out with the water, usually3-5 ounces, and
then press the hot water button again.
You machine is now ventilated (primed) and should be ready to go.
SOURCE: the machine has shown me with 'DECALCIFY VENTILATE' on the panel
Run the descaling procedure
SOURCE: Trevi Spidem Espresso Machine that leaks
remove the brew unit and look at the white valve behind it, below that valve there is a small chamber which is probably filled with coffee grounds and water, clean chamber and below chamber is a small discharge hole that leads into the draintray, make sure it is clear.
SOURCE: how to ventilate a saeco cafe royalecoffee machine
Hi
There is a water button you need to push. It has a water drop on it. This will clear the ventilate message.
1,895 views
Usually answered in minutes!
Hi I have the same problem, machine say decalcify
readout says ventilate
The machine is stuck on Ventilate and no Hot-Water/Steam can be dispensed.
how does this solve the decalcify message? I have used the decalcisying powder but message is there...
×