How do I solve error code 0002 on my epson pro 9800 maitenance error code 0002 unable to print

Yes, the error code indicates it is a thermistor problem and it means the problem is with the printhead of the printer, the solution for this problem is replacing the printhead, but before that, you can try to remove the printhead from the printer and then clean the contacts with a cotton swab and distilled water, after that dry them up and reseat the printhead very carefully.

You can take help from the service manual, which you can download from the link below.

http://www.americaninkjetsystems.com/epson_mimaki_roland_printer_rep/9800svc_manual.pdf

its a carriage home position sensor error u have to clean the sensor and the stip guide which has been attached on carriage... its due to dust on sensor.

problem with epson stylus pro 7880
how to removed error code A0000170

00010014 - Ink System Pressurization Error (The Pressure Sensor does not indicate pressure) CClick HERE to view full detail on troubleshooting process.
EXPLANATION:

The error codes in the table below relate to a faulty ink cartridge or detection of the cartridge when installed in the printer. These errors only occur when an ink cartridge is changed. Whilst you may be unable to quickly identify which ink cartridge may be at fault, the steps below provide a process of elimination.

did you used a non-original ink cartridge? if you did your printer says"ERROR 0001001B" is print head error. need to be replaced, send to repair.

SERVICE CALL 00010014
Description
Failure of pressurizing

Hi poulin,

Click here to access your printer's manual
http://support.epson.ru/products/manuals/000909/spro798400rg_e.pdf

Page 327 on that manual will contain information on how to troubleshoot service errors. On page 115, it talks about adjusting parameters for better print quality.

Hope you may use the manual to troubleshoot your printing errors on your own.

Don't print out of illustrator it causes a lot of heartburn. put the art into indesign or Quark and print from the layout program. That has always solved the problem for us.

cleaning unit end of life

The 00010014 error code indicates that the Ink System Pressure Sensor reports low pressure.
This error usually is caused by an Ink Cartridge that leaks pressure.

thanks for rating