How to record outgoing message Uniden cordless answer machine 6.0

SOURCE: philips dect answer machine cd2352s/05

Answer machine cut off , it may related to parallel phone detection, setting. So try not parallel any other phone with the DECT phone.

SOURCE: we have a uniden cordless phone with answer

Hello,
When you configured your telephone you must have come across the Remote Access option, in which you chose a secret remote access code or accepted the one by default. If you don't remember that then you should reconfigure it and choose a secret code different from the factory default.
While you are at it configure the Toll Saver option too. (more about that later)

When you are away you dial your home number and when you telephone invites you to leave amessage, enter your Remote Access code. You will be read various options, among which there is the Hear New Messages option (if there are new messages). After hearing your messages you hang up. and you will be charged by you telco.

With Toll saver On, you telephone answers after 2 rings, if there are new messages, and after 4 rings if there are NO new messages. If your telephone does not answer after the second ring (if you hear the 3rd ring) that means you have no new messages, and you can hang up without being charged by your telco.

Hope it helps.
Rate the solution.

SOURCE: How do I change the outgoing message on my Uniden

Recording a Personal Greeting
Your answering system comes with a pre-recorded outgoing message or greeting that plays when you receive a
call: “Hello, no one is available to take your call. Please leave a message after the tone.” You can record your own
personal outgoing greeting. Your recorded greeting must be between two seconds and thirty seconds long.
Press /mute. The system announces the number of new and old messages, then starts to play the
messages unless it has no messages.
Press 5 to stop the announcements or message playback. You will hear intermittent beeps indicating that the
system is in the command waiting mode.
Press 8 to start the recording. The system announces, “Record greeting.” Begin recording after the
announcement.
When you finish recording, press 8 again or press 5. You will hear a confirmation tone, and your recorded
greeting plays back for you.
Selecting a Greeting
Once you have recorded a personal greeting, the phone automatically switches to your personal greeting. You can
also switch back and forth between the pre-recorded greeting and your own greeting at any time.
Press /mute. The system announces the number of new and old messages, then starts to play the
messages unless it has no messages.
Press 5 to stop the announcements or message playback. You will hear intermittent beeps indicating that the
system is in the command waiting mode.
Press 6. The system plays the current greeting.
To keep this greeting: Do nothing..
To switch to the other greeting: Press 6 while the system is playing the current greeting.
Each time you press 6, the system switches between the pre-recorded and the personal greeting. The last
greeting you hear is used as the current greeting.
Deleting Your Personal Greeting
You can delete your personal greeting from the base. You cannot delete the pre-recorded greeting.
Press /mute. The system announces the number of new and old messages, then starts to play the
messages unless it has no messages.
Press 5 to stop the announcements or message playback. You will hear intermittent beeps indicating that the
system is in the command waiting mode.
Press 6. The system plays the current greeting. Switch to your personal greeting if necessary. (See the previous
section to switch the greeting.)
While the personal greeting is playing, press 4.
The system announces “Greeting has been deleted,” and switches back to the pre-recorded greeting.

Cheers!

SOURCE: How to set message for my uniden cordless ph /answering machine

• you really need to contact your service provider or you can get a new phone
  

SOURCE: Need to record Outgoing Message for Vtech 5.8 GHz

http://www.vtechphones.com/vtechui/support/manual_list.cfm