When turned on power button flashes screen dark plus blink very little?

The click is probably a short of some kind, possibly in the power control board. Please add the make and model of the tv and repost the query

The front LED light that shows whether the TV is on or off will flash so many ... press and hold the power button for 5 seconds upon plugging the TV in. ... The flashing code I got meant the power supply was bad.

If the set can be turned on manually without the remote then the issue is with the remote.

Plasma? Your power supply has bad capacitors. 3300uf most likely. This is a common problem on some Philips plasma TVs. Power board is located top center of the TV with the rear access panel removed. look toward the lower left portion of the board. If you notice any capacitors (they look like little plastic wrapped cans) with swollen tops or leaking dark fluid from the top of them, replace them. Myself, I always step up the voltage rating... ex: 3300uf, 10v -> 3300uf, 16v.

ASPIRE ONE BIOS FLASH RECOVERY

First format an USB stick with FAT.

Download the latest BIOS, and put both FLASHIT.EXE and the BIOS file in the root directory of the stick. Rename the BIOS file to ZG5IA32.FD, that's important. Do not remove the USB stick.

Turn the AA1 off, make sure both battery and AC adapter are connected. Press Fn+Esc, keep it pressed and press the power button to turn the AA1 on. Release Fn+Esc after a few seconds, the power button will be blinking. Press the power button once. The AA1 will now initiate the BIOS flash, do not interrupt it under any circumstances. After a while the power button will stop blinking, and the AA1 will reboot shortly after. Wait patiently.

The BIOS has been flashed and all settings reset to default.

If for some reason you made a mistake during the procedure and it doesn't reboot by itself wait 5 minutes before turning it off, just to be safe that it isn't still flashing the BIOS.

http://support.acer.com/drivers_download.aspx



http://blog.shimpossible.com/2007/07/18/white-screen-of-deat­h/

Could be the power module or the backlights (more likely backlights if the "luminance" varies)- $156 sounds a little high but not insane, but you realize cost of replacement is lower, do you not?

press 2nd and the down button (hold down button)

This sounds as if you are using the hibernate feature in windows reboot it and reset the power options to hibernate never check the vid connection as well

Turns out the little button on the top left of the device is for adjusting the contrast. Turn on the WorkPad. Press the little button. Then hold down the down button and the contrast will be adjusted.

Lens motor is shot - check out Olympus web site for repair options-not cheap