Misfeed on lanier 7320

please clean the sensors located in the RADF and power the machine and the problem is over

its a moisture issue in the paper. try nice new dry paper and i bet it works fine

check registration sensor actuator

It could likely be the drum. Is the line on copies and prints, or just copies? If it's just on copies, it's not the drum.

Press "clear/stop" and "8" at the same time. An error code will be displayed in the copy quantity window as long as those two button are held down. What is the error code? Each code is specific to different areas of the copier. I will be more than happy to assist you in resolving.

Hello sir; Pull out the paper tray ,check the paper senser is moving freely,clean the paper pick up roller, it will take care the problem.

I believe c-41 is a fuser problem. A trained copier tech may be required to troubleshoot.

I like your pictures.... Have you tried to clean the feed roller with a slittly damp rag with Simple Green or WD-40? You can try that and wipe the extra off. They both clean the rubber roller's. If that works good, that means the feed rollers are worn and need replacing. But you may also need the paper pick-up feed clutch. You said you can still run paper throw the by-pass. Good Luck

When you close the doors does the message disappear? If so then the paper pickup roller is worn. Open the cassette remove all paper apart from one sheet. Spray a alcohol based cleaned on the leading edge of the paper. Try and do a copy this will issue a jam and also clean the pickup roller. repeat a few times then clean out the cassette and dry off place new paper in the cassette and try. Also there maybe a piece of paper behind the cassette. Remove cassette and reach in and remove paper lodged at back.

Thanks Jason

Was the toner bottle removed before you moved the machine?