Can anyone provide instructions to change an oven igniter The stove works, but not the oven or broiler. The igniter works (it glows and I feel a lot of heat), but I don't smell any gas when I turn on the oven switch. Any suggestions?
Hi,
Please CLICK HERE for the instructions.
Goodluck,
Please don't forget to rate the solution.
Click here:
Changing a common gas oven ignitor
Starfish, remove the oven racks, in back there will be two chrome screws, remove them. Lift the lower oven panel out by pulling up from the rear. Remove the screws holding the flame spreader and remove the flame spreader. Now you will see the burner and igniter attached to it. There are 2 quarter inch hex screws holding the ignitor on. GE likes to put them on an angle where you cant get at them. If you have trouble you can remove the bottom drawer and remove the screws securing the burner to the back wall. There should be one in the front too. The burner will now lift up and you can get at the screws. The new ignitor should come with ceramic wire nuts. Just cut the old igniter, strip the ends of the wires going to it and wire nut the new one on. Reverse the rest of the steps. Here's a little trouble shooting schem. Catriver...post back.
Well..that's a gas issue, not an ignitor issue..did you check for the pilot to be active? or is this pilot less?
345 views
Usually answered in minutes!
×