The motor is making a loud vibrating noise - Maytag PAV2300 Top Load Washer

You have to find out from where the noise are coming (motor or from the front of the cleaner )
Motor- bearings or something gets in the fans of the motor
Front of the cleaner- check roller and holders at the end and 2 plastic covers true which cleaner sucking from carpet. That plastics sometimes get broken and vibrate

motor mount need to change asap before it damage more parts.

Hey friend, I appreciate your post!

I understand that your Electrolux gas dryer is making a loud vibration noise and is also loud while tumbling. There are several components in your dryer that could be causing this noise. Based off what you are describing it might be an issue with your suspension rollers, motor, or pulley. Since it could be any of these underlying issues I would suggest getting a technician out to diagnosis and repair your dryer. Hope this is helpful. - Matt

If it ismaking a steady noise, the motor that runs the defrost timer may be making noise. I f the timer motor is making a loud noise, then you should replace the timer.Vibration noises are often caused by dishes or containers vibrate on a shelf inside.

Could be a broker motor retainer. There should be two motor retainers in this model, when one is borken, it causes the unit to
shake and vibrate.

The only motorized part I am aware of is the lens focusing mechanism. If it's making a noise loud enough to be heard and vibrating, it is most likely defective. I suggest sending it back to Sony for service if it is still under warranty.

the fan motor could be failing. turn it on with the top off. if one of the fans is moving slower, that'd be the one. since this is a dlp projector, the colorwheel motor berings might be on their way out as well. both need replacement.

ok well its possible there may be something stuck in the blower motor under the passenger side dash. ..or the blower motor itself could be on its way out, sometimes leaves or sticks from trees and even stove inside the glove box can find their way into the windshield cowling and into your blower motor..u can remove it to check by unplugging its white connector and remove the 8mm bolts that secure it into the heater core box..its very easy to remove..the 8mm bolts / screws should also have a phillips head on them...

hi there
it sounds to me that you have two problems the
loud noise is the heater motor bushings is worn out causing the loud noise and vibration
also you will have to replace the resistor

once the motor is replace and the resistor replace all should be ok
don

noise you are hearing can be the fans inside with bad bearings and or what im assuming given the info you gave.More likely the motor inside the optics engine (color wheel) is making noise..This will also cause picture problems..very expensive to repair..