Beeps when i push buttons but will not start - Nordic Track C2255 Console (treadmill)

It's possible that the inside of the button has gotten some soap or "gunk" which is showing the button as being held on. Try and clean out around and behind the button, even a small squirt of WD 30 may loosen anything behind the button. Make sure the power is off before doing anything.

Hit the power button until there is NO display . Unplug and wait a minimum of 30 seconds , plug back in and within 30 seconds hit SIGNAL button then DELAY START button then SIGNAL button again then DELAY START button again. door should lock and display t01 It is now in test mode . There are 14 different test it can run through in this mode , but all we are trying to do is check for error codes now and maybe get you back to normal, So turn the knob one click clockwise and hit the START/PAUSE button and see if any error codes come up. To exit the diagnostic mode - hit signal button then delay start button then signal button then delay start button and you are out of service test mode and back to normal. Post any error codes.

You will need to replace the door lock assembly. Here is the part to order.

Open driver door.

Push and hold "f" key until remote beeps.

Push remote start button once so "pair" appears on screen. Push and hold "f" until remote beeps three(3) times to select pair mode.

Insert key into ignition an turn to "ON" position.

Push and release "valet" button on antenna, push again and hold until remote emits a series of beeps and displays "passed"

Hi,
There can be many reasons why your dryer will not turn...

This tip that I wrote will help you to figure out what is happening...

Dryer Repair - The Dryer is not Turning
http://www.fixya.com/support/r4422207-dryer_repair_dryer_not_turning

Dryer Repair ? The dryer will not start
http://www.fixya.com/support/r4460438-dryer_repair_dryer_will_not_start


heatman101

Is it still beeping? ;) It will beep if you have the automatic brewing programed and the grinder and it's lid are not in place.Once you have put the grinder back in place, push the small white button down that is on the grinder lid. The beeping will stop. Don't press the program button again or it will start beeping again...but if you do, just push that white button again.

push the down arrow til it beeps then push the up arrow til it beeps. Push the arrow up til you get to the number of hours you want it to run. Push the down button again til it beeps then push the up button again til it beeps. The pump will start running in 3 to 5 minutes

The door is not compltely closing. Make sure to push it in hard around the clasp areas. If yours has a light, the light should turn off and on as you open and close the door.

Is your grinder in and the lid down? My coffee maker (grind & brew) started beeping after I cleaned it and turned the left knob clockwise with the grinder still disassembled. There's a little button that is depressed when you close the lid with the grinder in there (I'd guess it's a safety feature). I pressed down that button, and the beeping went away.

Trying unplugging for 20 minutes maybe you can reset it.