E05 error on hotpoint ultima wasing machine - Hotpoint Ultima WF865 Front Load Washer

Communication Error, basically the module is not sending message to component to activate...see linkhttp://www.hotpointservice.co.uk/hs/pages/content.do?keys=FAQ:ERROR_CODES

• F05 - Pressure switch jammed on full - Check pump for blockages.
• I would recommend you pull out your machine and check the drain pipe and pump hope this helps.

Normal 0 false false false MicrosoftInternetExplorer4 /* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-parent:""; mso-padding-alt:0cm 5.4pt 0cm 5.4pt; mso-para-margin:0cm; mso-para-margin-bottom:.0001pt; mso-pagination:widow-orphan; font-size:10.0pt; font-family:"Times New Roman"; mso-ansi-language:#0400; mso-fareast-language:#0400; mso-bidi-language:#0400;} Fo5 is a pressure switch fault; areas to check are pressure chamber for blockage, pressure pipe sump and pump. Click on a link for more Hotpoint, Creda and Indesit error code definitions or Hotpoint WMA / WM workshop manuals

Hold In on/off and start buttons together for 10 secs.

Error F05 indicates pressure switch jammed on full.
Remove lower rear cover of washer.
Locate and remove large black hose fastened to drum.
Remove and clean filter inside hose.
Remove hose onto pump, and check for blockage or obstruction here as well.
This should solve the problem.

High Temperature Rise in Drying:
check fan motor & filter for blockage. basically a reduced airflow within drum unit

it's a motor problem. could be as simple as the brushes or could be the circuit board at fault.

Error E30 is a motor drive problem. Would check motor brushes as most likely fault.
Thanks for using Fixya.

F01 is a motor faulty normally caused by the module,but sometimes thewiring to the motor plug that works loose as its to tight,give them alla good wiggle make sure there all in!
check this link for other error codes of hotpoint machines
http://www.hotpointservice.co.uk/hs/pages/content.do?keys=FAQ:ERROR_CODES

f30 code means there is a problem within the motor curcuit,check connections at the motor and check motor brushes are not worn.