Alignment off the fax machine alignment is off and it will not print properly.

I don't believe there are any troubleshooting DIY guides.

The only thing I can think of is that something got into the printing drum, like a piece of paper, or a thread and that is interfering with the proper alignment of the wheels.

Hard to say without seeing the actual calculator.

Hi,

Follow below steps to complete alignment.

• With the Cartridge compartment cover open, insert the print cartridge into the print cartridge cradle with the contacts facing into the unit. When the cartridge is seated in the print cartridge cradle, push the top of the cartridge towards the back of the unit until the print cartridge clicks into place.
• Close the cartridge compartment cover and control panel.
• Press the Start/Enter button.
• On the keypad, press 1 if the replacement print cartridge is new or 2 if the replacement print cartridge is old

NOTE: When you put in a new cartridge, you must choose 1: New .When you put in a used cartridge, choose 2: Used . This helps you to check the correct amount of ink you have left.

• An alignment page will print and 06 [01-11] will show on the display
• Look at the alignment page and select the number under the straightest line, and then press that number on the keypad and then press Start/Enter .

You should load paper and press enter to align, The message will keep coming back until you let it do alignment or press enter and option buttons at the same time.

Make sure the side guides in the paper cassette are snug up against the paper.

The paper could be whacking a scrap of paper on its way through and skewing.

How can a get the # recalled of a document was fax to.

Function 74 set 12 set 2 set stop

Did you try cleaning the print cartridge nozzles.

Press Function once and up arrow 2 times
Press the right arrow once and the up arrow once
Press the right arrow once
Press Start/Memory button
It will print a test parttern page

Once you insert the new cartridge did the machine recognize the new cartridge? You had to press 1 for new

When 1 is selected you will get a prompt New Cart: OK?
OK press start.

If you selected NEW the display will show the alternating messages at right. Align Cartridge----1 Print 2 Set

Press 1 to print an alignment page

Hopefully, it will printed. Let me know one way or the other.

it sounds like either you didn't peel off the plastic cover the ink cartridge or it is a defective cartridge.

Thank You,

Mikey

make sure our cable connector is clean cheers