During wash cycle the washer stops at 11 or 12 minutes left and screen reads F . i have a frontload whirlpool duet HT

Maybe power was lost temporarily. Try pressing start / resume button. Or cancel cycle and start over. Also Check drain pump for obstructions.

F32 is a pressure switch failure. It controls the water level in the washer. The switch is a round plastic part mounted on the right panel towards the back right corner. Remove the switch by disconnecting the wire harness and the rubber tube connected to it and gently rotate it 90 degrees CCW and you should be able to pull it out easily. Some suggest that blowing on the tube will clean out anything that could be clogging it as a quick fix. If you suspect the switch you test it by checking two things; Blow on the inlet that was connected to the rubber tube you should hear a couple of clicks. The second test is to check if the switch works electrically. If the switch is bad you will need to replace it.

Read more: http://forum.appliancepartspros.com/washer-repair/7456-whirlpool-duet-f32.html#ixzz3S9ubaYUd
http://forum.appliancepartspros.com

Repairing the F02 error code can usually be done without ordering parts. Tools needed to repair your whirlpool Duet F02 error code are towels and a quarter inch socket.
Tip the washer back at a 45 degree angle. On the bottom panel there are three or four screws, with the screws removed the panel will slide down and off. With the lower access panel now removed you will have access to the washers drain pump clean out.
With the water already bailed from the washer you can twist the filter head counter-clockwise to remove. Twisting the filter head counter-clockwise will loosen filter so it can be pulled out.
With the filter out clean and install it back into washer.
Run a quick cycle to ensure the washer is back up and running and the F02 error has disappeared. If the error comes back, it may require you to clean the drain pump filter again.
If you require a new drain pump motor, you can purchase the part from the link below.
- See more at: http://www.appliancerepairlesson.com/2011/03/12/how-to-fix-whirlpool-duet-error-code-f02-duet-sport-error-f02-fix/#sthash.PuGd0iuQ.dpuf

Front load washers don't "agitate". Did you mean it doesn't tumble during the wash cycle? I need more information. Complete model # and a more detailed description of the issue.

Whirlpool Duet & Duet HT & Kenmore w/110 model prefix Frontload Washer Error Codes-OLDER

• F/H--No water detected entering machine or Pressure switch trip not detected
• F/02--Long Drain
• F/05--Water Temperature Sensor Error
• F/06--Drive Motor Tachometer Error
• F/07--Motor Control Unit Error
• F/09--Overflow Condition
• F/10--Motor Control Unit (MCU) Heat Sink Thermal Trip
• F/11--Serial Communication Error
• F/13--Dispenser Circuit Error
• F/14--EEPROM Error
• F/15--Motor Control Unit (MCU) Error
• Sud--SUDS LOCK (Overdose of Detergent detected during the Wash Cycle)
• F/dL--Door Lock Error
• F/dU--Door Unlock Error

check the pump filter it could be blocked or the drain hose try blowing down the drain hose to see if its clear you should hear a bubbling sound if not its blocked

Your motor may need nee carbon brushes

Have you tried running a cold wash? Could be a heating fault. If it runs a cold wash fine then id go with that as a starting point

F2 code is a drain issue. If you are not using he detergent you can cause slow draining and then you will get the code. Try using less detergent. Also, try disconnecting the power to the washer to reset controls.

make sure your drain hose is above the tub in the washing machine