Please check the following steps:
1.Turn the printer off and on to see if it can automatically clear some or all of the jam.
2. Turn off the printer. Remove any paper trays. Look for wrinkled or damaged paper.
3. If necessary, remove the toner or ink cartridge.
4. If you find a piece of jammed paper, remove it.
5. If the paper does tear, try rotating the roller gears manually to free the paper. Don't force anything, though.
6. Replace the toner or ink cartridge and paper trays.
**If this works please rate else let me know in case of further help.**
SOURCE: problem with paper feed - all sheets come out
Sounds like your fuser is bad, ink is not adhering to the paper and building up on a roller that is causing the paper to wrinkle.
SOURCE: Paper completely wrinkled
I have the same problem!! All of a sudden the hp 1300 started majorly wrinkling the left side of the paper (and occasionally the whole paper). I had to buy a new hp 1320 which has been fine. I decided to take this printer home and find the problem. I used to work for IBM...repairing office equipment. I cannot find the problem EXCEPT that there are pieces of torn "mylar"...charcoal color on one side and tan color on the other. I am sure that this has something to do with the problem. I can see a roller(?) from the "straight through" in the back. It is difficult to see. I think this "mylar" (?) is ripped and causing the paper to wrinkle badly. How do I replace the damaged mylar? What is this mylar?? It is impossible to take the covers off and get at this! I have nothing to lose...I am ready to throw this printer away...what a shame if it is something simple to fix!
SOURCE: Phaser 7700GX Color Printer prints wrinkled pages!
when this occurs the problem is most of the time with the transport roller, fuser / fixing assembly roller.question is the image still toner only and not fused to the paper.
In these areas there is offen a jammed and not removed piece of paper dislodged in the paper path or jammed in the fuser or the transfer rollers teflon coating has perished inspect the areas carefully and remove any found if the unit still is faulty (fanning of paper the fuser would be the first to be replaced are past there usable life) if so then Post a reply
SOURCE: wrinkling paper
I don't see any tear, but there is a piece of broken plastic that I can't get out. I almost had it with a pair of tweezers, but it slipped down inside where the paper comes out. Is there a way to get into there without destroying the printer? Is there an available diagram of how this roller comes apart?
Thanks so much for caring!!!
SOURCE: HP 1300 makes noise and wrinkles paper
open the back door. see if there are small Pisces of plastic the color will brown or gray. if there is then the fuser sleeve has worn out. very common problem. part is a bout $40.00.
884 views
Usually answered in minutes!
×