Bosch Nexxt 100 series washer stops at 1st spin cycle

Does the problem occur on both hot and cold washes. If not then check the inlet solenoid . If yes than check the board.

Maybe you just need to change the motor brushes. YouTube has some great videos. Spares here on Fixya. Did you check out your filter?

Click if helped.

Cleaned out the drain hose from the front panel. Seems to be working fine now.

Thanks

Possible that the main motor is jammed or does not get power from the program controller unit. It is important that you measure the voltage at the motor when the program is set to start after the inlet valve fills water. If there is no voltage then the program controller unit is faulty.
Click this link for support : washing machine tips

I realize that this post really old but I wanted this to be available for the next guy. I bought Bosch part number 154740 which are brushes that worked for me. They will tell you it wont work but it did for my Bosch (wfmc1001uc/09) washing machine.

does it spin and no pump, or pump and no spin or neither does it come to end of normal wash and stop before spinning.

no matter which make / model of washer you have you should clear the filter regularly; i do mine every 2 weeks , just in case....i learned this the hard way when the washer wouldnt finish cycle. there may be a bit of water in the system so be prepared for an amount of water

check drain pump and filter...

Nexxt 100 Series WFMC1001UC Front Load Washer This washing machine tutorial will show you what to do if the washing machine does not drain or empty the water out this repair was done on a Bosch, Neff and Siemens type appliance.
Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question.

It is most likely out of balance, could be for many reasons.
1 could be too many heavy items such as jeans, towels, etc in one load.
2 could be the machine or floor is unlevel.
3 Could be a balance sensor needs replacing.