My computer crashes whenever I disconnect my fast track

Removal & Installation

Specific to:
Hyundai Entourage 2007-2008

1. Before servicing the vehicle, refer to the Precautions Section.
2. Disconnect the negative (-) battery terminal.
3. Remove the crash pad lower panel (A).
   
   
   
   Fig. Remove the crash pad lower panel (A)
4. Remove the 2 screws (A) and the trip switch connector.
5. Remove the crash fascia panel (B).
   
   
   
   Fig. Remove the crash fascia panel (B)
6. Remove the screw with the ignition in the ON position (IG ON) and disconnect the 6P connector.
7. Remove the ignition switch (A).
8. Installation is the reverse of removal procedure.
   
   
   
   Fig. Remove the ignition switch (A)

Specific to:
Hyundai Accent 2006-2008
Hyundai Azera 2006-2008
Hyundai Elantra 2006-2008
Hyundai Sonata 2006-2008
Hyundai Tiburon 2006-2008

1. Before servicing the vehicle, refer to the Precautions Section.
2. Remove or disconnect the following:
   
   The negative battery terminalThe crash pad lower panelThe ignition switch after loosening the screw with IG ON and disconnecting the 6P connector
3. Installation is the reverse of the removal procedure.hope this helps it is off autozone website

I have the same problem. Here is what it looks like. Any ideas? This happens without any inputs. I'm using a macbook air on yosemite but I have tried it with ealier macs and still.

Open up your computer to check usb connection make sure the connection is good and dust free
or you might have to clean the dust using a fine air blower from a compressor making VERY sure that there is no MOISTURE in the air line specifically around the CPU central processing unit and your sound card dust causes static to build up in a computer causing it to overheat any many other problems
be sure to wear an anti static earth strap before touching anything inside your computer
hope this helps

All you have to do is to connect with 2 cables your mixer's output to the two 1/4” TS plus in the front side of the Fast Track Pro and a usb cable from the rear panel of the Fast Track Pro to your pc's usb port. I suppose that you have installed the drivers for Fast Track Pro at your pc.
Anyway in case of a problem or clarification, don't hesitate to post.

Thanks and regards
Please kindly rate this solution
Stelios

First thing is what operating system is on the computer.
Second is what does device manager say about the recording interface?
Third in audio properties from the task bar icon, what is the default device for recording?

Options>Audio>Advanced.......

Select "MME" from the Driver Mode dropdown menu....

this worked fine for me......
let me know if it works...

All you have to do is to connect with 2 cables your cd's or dvd's output to the two 1/4” TS plus in the front side of the Fast Track Pro and a usb cable from the rear panel of the Fast Track Pro to your pc's usb port. I suppose that you have installed the drivers for Fast Track Pro at your pc.
Anyway in case of a problem or clarification, don't hesitate to post.

Thanks and regards
Please kindly rate this solution
Stelios

check the printed circuit board, check for cut lines

try and see if it is in MY COMPUTER if it is there download the newest firmware and update it if that doesn't work uninstall the mp3 player from your computer and then installit again.

Have you tried updating the firmware. Even if it is the lastest edition, download the firmware manually and run the software. Then format in Windows Media player. Best Regards Keith