Need wiring diagram for washburn lyon guitar - Washburn X10 Electric Guitar

You can try looking for a wiring diagram for your Washburn Pro X series guitar at the following places:

1. The Washburn website: The manufacturer's website may have wiring diagrams available for download for their guitars.
2. Online forums: Online guitar forums such as the Washburn Forum (https://www.washburn.com/forums/) may have wiring diagrams posted by other users, or you can post a request for one
3. Luthier: A Luthier or guitar repair specialist may be able to provide you with a wiring diagram for your guitar.
4. Online guitar parts retailers: Some online guitar parts retailers may have wiring diagrams available for download on their websites.

Please note that the wiring diagram may vary depending on the specific model and year of your Washburn Pro X series guitar. It's best to check the wiring diagram for your specific guitar model to ensure that it is accurate.

These are not expensive guitars new. I think $75 is the most I'd go.

I would imagine it to be similar to this. this is standard wiring for your situation. although you may not have these exact pick-ups. the wiring remains the same. Good luck

It's probably 1995 Washburn Lyon WE3, the pickup configuration is two single coil pickups. It would be easier to tell if there was a photo available.

Just google "washburn wiring diagram" Nice pix come up.

Try this site... find the configuration of pickups and controls and then select that set:

http://www.guitarelectronics.com/c=Ijshs0QUDUCFOzkjYu7hSxoe4/category/wiring_resources_guitar_wiring_diagrams/

READ MANUAL IT CAME IT MAY HELP YOU ADJUST TRUSS BAR.

It is pathetic that information is so hard to get on these. The best I can offer is this site where you can sort through the types and configuration and find one that matches:

http://www.guitarelectronics.com/category/wiringresources/

It sounds like the grounding/earth wire is off the output socket as you already seem to believe yourself. Depending on the model either take off the back control cover panel or the scratchplate/pickguard and look for a loose wire running from the back of one of the pot cases and connect this back onto the screen connection of the jack socket.

This is the way most aftermarket pickups are set up. Its to accommodate different wiring setups like coil splitting.

http://www.seymourduncan.com/support/wiring-diagrams/schematics.php?schematic=2h_2v_2t_3w

Whether the pickup is a Duncan or not does not make a difference. Make sure you solder the red and white wires together(the ones together in the diagram) and cover the joint with heat shrink or electrical tape.