I have a pf code and it wont cool - DeLonghi Pinguino PACL90 Portable Air Conditioner

Try a Power Reset.

What does PF mean on a Rinnai heater?

Gzipwtf.com https://gzipwtf.com > Helpful tips
Sep 9, 2019 - A PF (Power Failure) error code indicates that the drying cycle has been interrupted by a power failure. Touch and hold START to restart the ...

RHFE-556WTA

Rinnai https://media.rinnai.us > salsify_asset > RHFE-5...
The Energysaver 556 has the ability to check its own operation continuously. If a fault occurs, an Error Message will flash on the Digital Display of the ...
64 pages

The PF is a power failure code and it indicates the control is not sensing any line voltage
Check the circuit breaker for the dryer is not tripped. The PF could be caused by a voltage drop during a storm but you should be able to clear it and run the dryer

pf stands for power failure. try unplugging the unit and then wait for about 15 mins or so and then plug back in and see if that will reset the code.

\I am not sure y it is giving the PF code because that code is saying there has been a power failure. U could be right in the direction you are thinking.

Hi,

Here is a tips that I wrote that will help to explain why you get the PF Error Code

PF Error Code for Appliances

heatman101

,././;'';

Hi,

PF refers to Power Failure.Press Cancel and Check, if that clears the error. If the problem persists, it might be a Faulty Control Board.

Now,

Before that, as you never mentioned Did you try to use Self-Cleaning? If yes follow the below procedure :-

1. Unplug the Circuit Breaker for 5 minutes.Turn On the breaker and then try to open the door.

2. Again go for self clean option but for few minutes, say 15 minutes.Cancel the self self after this and allow the Oven to Cool. After some time, then try to open the door.

Let me know, if need further assistance.

Hope i helped you.

Thanks for using ' Fixya ' and have a nice day!!

PF - Power Failure - PF error code indicates a power failure during the dryer's cycle. Press and HOLD start to continue the cycle, or press off/pause to clear display.

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question

PF is general failure code, repairing it cost about $150, is the unit under guaranty?

Error codes. are any of these lit? PF Power failure "PF" flashes to indicate that a power failure occurred while the dryer was running. Press HOLD TO START to continue the cycle, or press OFF/Pause to clear the display. E1 Thermistor open Replace thermistor if found defective E2 Thermistor shorted Replace thermistor if found defective