Hi Guys Rexel Cosmos 210 Stapler (Staple Gun - Mk II) I have a Rexel Cosmos 210 Stapler that has a broken white plastic bit. I have had it and used it at work for about 25 years. How can I get a replacement part? I live in Brisbane, Australia. Regards, John

try where you got it .OR
https://www.google.com/search?q=rexel+2001+staple+gun&oq=rexel+2001+staple+gun&aqs=chrome..69i57&sourceid=chrome&ie=UTF-8

Search Results

Stanley electric stapler/brad nailer - YouTube

? 5:06
https://www.youtube.com/watch?v=Zbgt2UXpS-M
Dec 29, 2013 - Uploaded by Tindlez
How to load staples and brad nails in Stanley electric staplermodel TREE550 ... Stanley SharpShooter Manual Staple and Brad Gun review ...

Stanley Electric Staple/Nail Gun (TRE550) - YouTube

? 5:04
https://www.youtube.com/watch?v=6JTZJjQ3wlA
Jan 5, 2015 - Uploaded by HowToWith GEO
This video tests the Stanley electric stapler and nail gun. Model TRE550. This video will test both staples and brad type nails. ...Stanley SharpShooter Manual Staple and Brad Gun review - Duration: 9:35. Unpack Guy 43,106 ...

Safety Tips for an Electric Stapler : How to Load Staples into ...

? 1:01
https://www.youtube.com/watch?v=dMsdmYBoojU
Feb 5, 2008 - Uploaded by expertvillage
Learn how to load staples into an electric stapler in this free educational video ... Stanley Electric Staple/Nail Gun (TRE550) - Duration: 5:04.

How to Use Staple Gun Staple Gun Tutorial

Hi Maria, I'm sorry you are not having luck with your JT27 stapler. Unfortunately you did not purchase the correct staples for this tool. The JT27 Stapler uses the JT21 staples in a green box. The staples come in 3 different sizes (1/4", 5/16", 3/8"). You can purchase these staples online or at your local Home Depot or Lowe's Store.

As for opening the tool - please see the attached picture for assistance.

Could be a bad power cord: broken wire at the switch; a bad switch; the stapler needs lubrication; or the stapler is shot.

If you imagine that the end that the staples come out of is the front, then the back is where you load the staples. Your picture shows a small black bit at the very back of the stapler. You have to remove this, usually by pushing it in and lifting it up. Once loosened, it should pull out from the back of the stapler. You should then be able to reload. Finishing is the reverse process.

There's a plastic button on the back of the Rexel stapler that says "press."

Rexel Odyssey heavy duty stapler: The pring that pushes the staples into position can come losse if the stapler iss dropped. It's difficult to work out how to replace it! However, there are only two "lugs" that will take the circular ends of the spring. One obviously fits to the sliding staple retainer. The other to the back end of the pressed-metal inner body. However, to work, the spring must be threaded from this point along the pressed metal parallel-sided inner body back through a slot and over a rounded bent piece (shiny from prvious friction) and back down to the sliding staple retainer. It's trickey to do, but that's where it has to go in order to provide forward tension when the Stapler is closed.

1 Hold stapler upside down.
2. Release black plastic catch at rear and pull out.
3. Drop staples into bottom of gun, with open side up.
4. Push black plastic catch closed and latched.

wallyp