Remote don't work properly

Some remotes might fail to make changes properly or cause incorrect operation if a button "jams" in a pressed position, and doesn't release; or the filaments inside the remote become dirty or damaged (sometimes from spills). Ideally check with a different identical remote with the batteries removed on your original so it can't interact with the TV. Also check if your TV has control buttons at the TV to test the tv and hdmi change settings. (Do those checks with batteries removed from remote). If changes at the TV controls work properly most likely the problem is with the remote control.

When battery is changed, all the previous settings will be lost from the remote control. You should once again set it to your device, using codes.

remote entry wont work because either remote battery is dead or remote broken.cluster light will stay on if head light stay on could have faulty headlight relay or headlight control unit faulty let dealership check it out.

Try 124 code, might work for combo unit.

Hi:
The IR receiver inside the television is becoming intermittent and needs to be replaced. You might also check the connections on the receiver small circuit board for cold or loose solder joints.

try to reprogram your remote ,
search the code of your TV from the user manual of your remote.

try to remove the batteries from remote, if that don't work, unplug main unit from wall for 40 Min., and it will reset back to normal.

Take off the battery, open the back of your remote, lift the circuit board, clean the green painted part with cotton balls slightly damp with rubbing alcohol as well as the black thingy behind your remote pad, let it dry put it back together, replace with a new battery and try if it works.

1st step, replace battery of remote, no result, 2nd step, check / replace Remote Sensor of TV.