I have an error on my w8200, on the screen

Hello,
Try this:
1) As an error (E02802 or E02805 to E02809) is shown on the display, install the correct
combination of printhead and ink tanks according to the error.
2) Perform ink filling*3 following the installation sequence. After filling ink, when "Load Roll
Media" is shown on the display, turn off the power.
3) Turn on the printer while holding down the ONLINE button, ENTER button, CANCEL button,
and PAPER SOURCE button.
4) Check that "Canon W8200" is shown on the display, and then release the buttons. When
printer enters Reset mode for the dye/pigment model setting, all the LEDs on the operation
panel turn on.
5) "TYPE RESET" is shown on the display.
6) Select "YES", and then reset the dye/pigment model setting in the printer.
When reset is selected, the ink drain sequence is executed. It takes approximately 4
minutes for the process to be completed.
7) Check that "Turn Power Off!!" is shown on the display, and then turn off the power.
8) Unplug the power cord from the outlet.
9) Move the carriage, and then takeout the printhead.
10) Replace the following parts
• Ink tube unit : See "Part 5: 5.2.6 Ink tube unit".
• Purge unit : See "Part 5: 5.2.9 Purge unit".
• Ink tank unit : See "Part 5: 5.2.10 Ink tank unit".
11) Turn on the printer, and then continue with the installation operation (from installation of the
printhead). At this time, replace the printhead with a new one*4.


For service manual, You can write me on [email protected]

Hope that helps!

EO 2506 = No Black Ink Tank or the tank not set properly try to pull it out and put it back again

There are no drivers yet for Canon imagePROGRAF W8200 on windows 7

Error Code E02E05 = Problem with Ink Cartridge door. you must unplug the printer. Turning on the on/off button is not enough. Then the printer ask you to remove the empty cartridge and open the
door, canceling the E02E05 error.

There was no response to the question, so we called in a Canon service person who has ordered a replacement print head.

Yeah...I meant the whole printhead assembly.

Clean the round rod that the print head moves along and also the metal work above where the carrage rollers run.
I wipe mine with a drop of oil after cleaning as error is indicating that the carrige is sticking and not moving at the correct speed.

Chris

you need to enter a service mode before the error message pops up. hold down paper source button + online.
that should override the message before it pops up.
go to replace print head selection. or do a clean. it may still be working. let me know if this doesn't work....but at least you can still get past the message now! marty

This means that your canon printer has had a ink discharge and is covered up and there is ink laying on the sensor, The sensor if it has went out is 20 bucks you can find at a canon parts retailer

Error Code E02D02 = Clean de coding tape behind the rubber belt.
Error Code E02B05 = Problem with de ink cartridge door.