At first i could turn it on and it would have a good picture for about a minute then it would go black.i would turn it off and back on but still black and standby light blinks continuosly.i could turn it off and wait for about 30 minutes to one hour,turn it back on and have a good picture again for about 1 minute,then black again.after doing all this a few times i unplugged it for 5 hours.when i plugged it back up and turned it back on it would'nt light up at all.
Check for any cold solder on the high voltage section of your tv A high voltage section is located at the power supply section, this is where the power cord is connected.resolder them,the horizontal section it is where the plyback transformer is located resolder them and the CRT board this is the boad that is attatched to the picture tube...good luck
please rate my help..
185 views
Usually answered in minutes!
×