Change all the caps. if the problem remain you have to load the firmware{factory software} again.
IF THETWO BLOWN CAPS WERE IN YOUR POWER SUPPLY REPLSCE THE POWER SUPPLY SOMETIMES EVEN WHEN WE CHANGE THE CAP
THE POWER SUPPLY IS BAD
Capacitors supplied with tv are 10v should be 25v known fault contact samsung they will repair for free 0330 7267864 is the number
SOURCE: power light comes on and clicking is heard but no
your problem is more a defective y board with y buffer boards one of them is short
SOURCE: Samsung LN52A550P3FXZA LCD had clicking
Hi.
If there are very faint picture in background, then the back light system is not working. That means that problem is either inverter powering the lamps with AC, main controller board managing the inverter, or PSU providing primary DC voltage to the inverter.
In your case the PSU was defective. The damage may have concerned more components apart the capacitors (resistors, more capacitors, solder joints etc.). Testing is done tracking voltage to inverter. The first thing to test is voltage to inverter from PSU. A general procedure is described here.
This test is done reading the DC voltage from the PSU to main controller. A malfunctioning controller board may not turn on inverter. Voltage in input and high voltage on inverter must also be checked. Voltages to check are 120VDC at CN801 on IP board (inverter power board) and DC B13V,B12V,B5V Voltages at BD105L,C1261,BD101 on PSU. For safety reasons testing with power on must be done by a trained person.
To make things easier, the whole service documentation has been uploaded here.
Here parts for this TV.
Regards.
Ginko
SOURCE: Samsung PN50B450 plasma tv model # pn50b4450b1d
That problem is usually cause of faulty y sustain board..It is looks like OK but the system was faulty..Try to replace it to fix the issue..
324 views
Usually answered in minutes!
×