Well as I cant be specific as ive never heard of this model even, but I know washers in general pretty well , I can say if you have a digital display that tells cycle time (again un usual) and it stops timing , this seems a pretty sure thing you have an electronics problem , most likely in the circuit boards themselves , but if your not sure of what does what , it might be a little less expensive to enlist someone that does b4 just shotgun replacing boards because they can get expensive !!
SOURCE: G892-SC Miele water intake/drain light blinks
The intake/drain light blinks. How do I fix this problem?
SOURCE: dishwasher stops after 10 minutes inlet/drain light flashing
I had the same problem on a 5 year old model. It was the main pump leaking from a perished seal causing the water protection microswitch to trip. This gives the symptoms you describe exactly. Parts cost from Miele was about £60 for a new seal. Fairly easy to fit.
SOURCE: Miele G 7856 Commercial Dishwasher
Hi. The above machine stops mid cycle and drain/fill light is on, also
error code F3E, have cleaned both hot and cold water inlet filters, also
checked drain pump and drain line, all ok. Machine drains with no
issues and fills with hot water, runs for a while then shuts down.
Any ideas?
SOURCE: Miele Optima G 2430 -
Hi The first thing that should be checked is if its draining
properly as it could be that the drain hose is clogged and needs to be cleaned.
The drain pump also should not be clogged. Also the stopcock should be opened
fully and the water inlet valve should be checked for any clogs. Also the metal filter, impeller cover and the air gap unit should be
checked. After checking this you can reset the error as follows: turn the rotary selector
switch to "Stop/End" or press the "Start/Stop" switch for
approx. 5 secs. Then switch the appliance off and then back on again. Hope this helps...please post back for further assistance. Daniel
217 views
Usually answered in minutes!
×